- 您現在的位置：買賣IC網 > PDF目錄372453 > TDA7514 (意法半導體) SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR PDF資料下載
參數資料
| 型號： | TDA7514 |
| 廠商： | 意法半導體 |
| 英文描述： | SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR |
| 中文描述： | 單芯片F(xiàn)M /調幅調諧立體聲解碼器和音頻處理器 |
| 文件頁數： | 64/74頁 |
| 文件大小： | 604K |
| 代理商： | TDA7514 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
TDA7514
64/74
VARIABLE-BANDWIDTH SELECTIVITY SYSTEM (ISS)
The TDA7514 is equipped with the Intelligent Selectivity System that automatically performs IF bandwidth
reduction in presence of strong adjacent channels or weak desired signal. A three position filter is available
at IF2; its bandwidth settings are: 120 kHz, 80 kHz and 22 kHz (the latter only for additional on-board WB
filtering). The filter is positioned between the 2nd mixer and the IF2 limiter. The filter is switched among
its OFF, 120 kHz and 80 kHz positions by a dedicated quality detection circuit.
The conditions that are detected in order to drive the filter position are:
– adjacent channel presence;
– peak frequency deviation magnitude;
– field strength.
The adjacent channel detection (programmable filter shape and gain, programmable rectifier gain, pro-
grammable flag generation thresholds, programmable integrator charge/discharge currents) can be par-
tially or totally disabled, if so programmed, when a strong multipath condition is detected (filter shared with
quality circuits with programmable gain, independent rectifier with programmable gain, programmable in-
tervention threshold). The adjacent channel detector is further disabled when the field strength is lower
than a programmable threshold (slope programmable as well). The output of the detector are two flags
signalling a moderate or a strong adjacent channel presence.
The peak frequency deviation is detected by rectifying and peak-detecting the mono part of the MPX signal
(programmable integrator charge/discharge currents, programmable thresholds). The deviation detector
is desensitized at weak field strength (programmable threshold). The output of the detector are two flags
signalling a moderate or high amount of peak deviation.
The field strength is measured against a programmable threshold and generates one flag.
These five flags are combined to control the ISS bandwidth by access to a 3-D matrix that can be pro-
grammed almost completely: it is therefore possible to specify the filter bandwidth for almost all the pos-
sible flag combinations.
The ISS filter may be disabled by setting the tuner SEEK bit to "1".
5.1.4
The demodulator output is passed through muting attenuators before becoming available externally for
the connection to the stereo decoder. The muting and output buffering are shared with the AM circuit.
The FM muting circuit is sensitive to weak field strength and to the presence of adjacent channel. The
weak field strength condition (soft mute) is detected by comparing the 1 second-filtered Smeter with a pro-
grammable threshold. The soft mute depth and slope are software-programmable.
The soft mute is followed by the adjacent channel muting circuit. The presence of adjacent channel is de-
tected as high frequency noise in the MPX signal, so that only the adjacent channel that is not suppressed
by the ISS can activate this muting. The filter is described in the Quality section. It is desensitized under
weak field strength conditions. The adjacent channel mute threshold/slope and depth are programmable.
The output audio amplifier gain can be switched to a +23.5 dB setting in WB in order to equalize the FM
and WB 100% modulation audio levels.
ISS-dependent automatic roll-off compensation is implemented before the output buffer.
SOFT MUTE AND MPX OUTPUT
5.1.5
The station detection function makes use of signal strength measurement and of IF counting. The result
is available on the SD pin as a logic high value when the tuned channel is considered valid. On the SD pin
the two field strength-related and IF counter output signals are also available separately by suitably pro-
gramming the output multiplexer.
The field strength-related digital output is derived by comparison of the filtered Smeter (the time constant
is 1s in reception and 100us in seek mode - see Quality section) with a programmable threshold.
The FM IF counter circuit detects whether the IF signal is centered inside a programmable frequency win-
dow around the nominal frequency value. The measuring time window is programmable as well. The result
STATION DETECTION
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7528 | AM/FM car radio Front-End receiver for IF sampling tuners |
| TDA7575 | MULTIFUNCTION DUAL BRIDGE POWER AMPLIFIER WITH INTEGRATED DIGITAL DIAGNOSTICS |
| TDA8175 | TV VERTICAL DEFLECTION OUTPUT CIRCUIT |
| TDA8176 | TV VERTICAL DEFLECTION SYSTEM FOR TV AND MONITORS |
| TDA8177F | VERTICAL DEFLECTION BOOSTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7515 | 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7515_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
| TDA7515A | 制造商:STMicroelectronics 功能描述:TDA7515A - Trays |
| TDA7515ATR | 制造商:STMicroelectronics 功能描述:TDA7515ATR - Tape and Reel |
| TDA7515TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
發布緊急采購，3分鐘左右您將得到回復。