- 您現在的位置：買賣IC網 > PDF目錄372453 > TDA7514 (意法半導體) SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR PDF資料下載
參數資料
| 型號： | TDA7514 |
| 廠商： | 意法半導體 |
| 英文描述： | SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR |
| 中文描述： | 單芯片F(xiàn)M /調幅調諧立體聲解碼器和音頻處理器 |
| 文件頁數： | 65/74頁 |
| 文件大小： | 604K |
| 代理商： | TDA7514 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
65/74
TDA7514
is available both on the SD pin and in the tuner I
2
C bus read byte.
5.1.6
The FM quality section of the TDA7514 generates the control signals for all the quality-related functions.
These quality signals are: filtered Smeter, adjacent channel content, multipath content. The controlled
functions are: AGC keying, soft mute, adjacent channel mute, stereo blend, high cut, audio noise blanker.
Externally available quality signals are also generated by this circuit. These signals are: filtered Smeter
(analog and digital), adjacent channel content and multipath content.
External filtering to generate part of the quality signals uses external capacitors: the voltage values on
these capacitors can be kept stored during RDS AF update or fast charged when a new tuned frequency
is selected.
The Smeter filter uses an external capacitor to generate a low-pass time constant of 1 s in reception mode
(10 ms for fast car-radio testing), and an all-internal circuit for a low-pass time constant of 100 us for RDS
AF update. The voltage across the capacitor is stored during RDS AF update; it is fast charged following
the 100 us-filtered signal during jumps to a new frequency. The 1s/100us Smeter is fed to the station de-
tector, to the high cut filter, to the soft mute and to the A-to-D converter.
An internally filtered 1ms-time constant Smeter is further generated to drive the keyed AGC, the ISS and
the weak field filter desensitization circuits.
The stereo blend function is driven by a combination of weak signal strength-, adjacent channel- and mul-
tipath-related information through the SNC (stereo noise control) signal. The SNC signal is a wired-OR of
the three conditions and is generated with a peak holder featuring a 400 ms attack time constant and a 10
s decay time constant. The Smeter contribution to the SNC is programmable in terms of gain and offset;
the same is true for the two other bad quality indicators (filter shape, rectifier offset and gain are program-
mable) keeping in mind that the adjacent channel filter and rectifier are shared with the adjacent channel
mute circuit and that the multipath filter is shared with the ISS multipath detector. The voltage across the
external SNC filtering capacitor is stored during RDS AF update, and is driven by a fast charge circuit dur-
ing jumps to a new frequency. A fast car-radio test mode is also available in which the external capacitor
is disconnected and substituted for by a much smaller internal capacitor.
A faster attack of the stereo blend function in case of sudden onset of adjacent channel or multipath con-
ditions is ensured by actually driving the stereo blend circuit by a further wired-OR circuit sensing the SNC
voltage as well as the unfiltered multipath and adjacent channel rectifier outputs.
The quality signals available to the u-processor are: filtered Smeter (on the dedicated buffered SMETER
pin), the multipath information (on pin QUALMPOUT), a programmable combination of multipath and ad-
jacent channel information (on pin QUALACMPOUT), and 6 bit digitized filtered Smeter (via the tuner I
2
C
bus read byte).
QUALITY
5.2 AM TUNER SECTION
5.2.1
The AM tuner front end section consists of a high IP3 mixer whose outputs are common with the FM first
mixer.
After going through the first FM IF1 ceramic filter the signal enters the second mixer for conversion to the
second IF of 450 kHz where channel selection takes place. The second mixer exhibits a high IP3 value
too, and has a fixed gain.
The front end AGC detects mainly a wide band signal (RF signal from the input pins of the first mixer) and
a very narrow band signal (Smeter, generated by the signal at the input of the IF2 amplifier after channel
selection has occurred). A third fairly narrow band input (IF1 signal from the input pin of the second mixer)
is also available, although the first mixer-input-referred IP3 figures of the two mixers make this input gen-
erally superfluous. The FE AGC starting points on all three input channels are programmable.
The FE AGC circuit drives the external attenuation P-I-N diodes and the external RF amplifier gain control
terminal.
FRONT END
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7528 | AM/FM car radio Front-End receiver for IF sampling tuners |
| TDA7575 | MULTIFUNCTION DUAL BRIDGE POWER AMPLIFIER WITH INTEGRATED DIGITAL DIAGNOSTICS |
| TDA8175 | TV VERTICAL DEFLECTION OUTPUT CIRCUIT |
| TDA8176 | TV VERTICAL DEFLECTION SYSTEM FOR TV AND MONITORS |
| TDA8177F | VERTICAL DEFLECTION BOOSTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7515 | 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7515_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
| TDA7515A | 制造商:STMicroelectronics 功能描述:TDA7515A - Trays |
| TDA7515ATR | 制造商:STMicroelectronics 功能描述:TDA7515ATR - Tape and Reel |
| TDA7515TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
發布緊急采購，3分鐘左右您將得到回復。