- 您現在的位置：買賣IC網 > PDF目錄383875 > T7234 Compliance with the New ETSI PSD Requirement PDF資料下載
參數資料
| 型號： | T7234 |
| 英文描述： | Compliance with the New ETSI PSD Requirement |
| 中文描述： | 符合新的ETSI PSD的要求 |
| 文件頁數： | 27/116頁 |
| 文件大小： | 1056K |
| 代理商： | T7234 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
Data Sheet
January 1998
T7256 Single-Chip NT1 (SCNT1) Transceiver
Lucent Technologies Inc.
23
Microprocessor Interface Description
(continued)
Registers
(continued)
Table 6. Global Device Control—S/T-Interface (Address 02h)
Reg
GR2
Default State
on RESET
R/W
R/W
Bit 7
STOA
1
Bit 6
ACTSEL
ACTMODE/
INT pin
Bit 5
TDMEN
1
Bit 4
U2BDLN
1
Bit 3
SXE
1
Bit 2
SRESET
1
Bit 1
Bit 0
FT
1
SPWRUD
1
Register
GR2
Bit
0
Symbol
FT
Name/Description
Fixed/Adaptive Timing Control.
Controls mode of timing recovery on S/T-inter-
face if TDMEN = 0 (register GR2, bit 5). If TDMEN = 1, FT is ignored.
0—Fixed timing.
1—Adaptive timing (default).
S/T-Interface Powerdown Control.
When 0, this bit forces the S/T-interface to
remain in a powerdown mode. This is the same low-power mode the S/T-interface
is in when the T7256 is in its IDLE state with no activity on the U- or S/T-interfac-
es. In this mode, all S/T-interface circuits are powered down, except for circuits
required to detect an activation request from a TE.
0—Powerdown.
1—Normal (default).
S/T-Interface Reset.
While 0, this bit causes a reset of the S/T-interface, initial-
izing the interface in the same manner as the external RESET pin. Must be set to
1 for normal operation.
0—Reset.
1—Normal (default).
S/T-Interface D-Channel Echo Bit Control.
Controls data in E channel from NT
to TE on S/T-interface. This bit must be cleared during 2B+D loopbacks to meet
ITU-T I.430 requirements.
0—All 0s.
1—Echoes D channel from S/T receive path (default).
Nontransparent 2B+D Loopback Control.
When 0, this bit causes a nontrans-
parent loopback of 2B+D data from U receiver to U transmitter upstream of the
data flow matrix. Note that this loopback path is not as close to the S/T-interface
as the transparent loopback initiated by U2BDLT (register ECR0, bit 6). This loop-
back may be useful for test purposes. When this bit is set, the upstream data (NT
to LT direction) will be forced to all 1s until either ACTR = 1 (register CFR1, bit 0)
or XPCY = 0 (register GR1, bit 5).
0—2B+D loopback. All 1s 2B+D data is automatically generated towards the
TE.
1—No loopback (default).
TDM Bus Select.
Selects functions of pins 4, 7, 8, and 9.
0—TDM bus functions. Pins 4, 7, 8, and 9 configured as FS, TDMDI, TDMDO,
and TDMCLK, respectively. See DFR1 and TDR0 registers for TDM bus
programming details. Microprocessor register bits GR11, GR12, and GR20
control the PS2, PS1, and FT functions.
1—No TDM bus. Pins 4, 7, 8, and 9 configured as SYN8K/LBIND, FTE, PS2E,
and PS1E, respectively (default).
GR2
1
SPWRUD
GR2
2
SRESET
GR2
3
SXE
GR2
4
U2BDLN
GR2
5
TDMEN
相關PDF資料 |
PDF描述 |
|---|---|
| T7234A | Compliance with the New ETSI PSD Requirement |
| T7237A | Compliance with the New ETSI PSD Requirement |
| T7256A | Compliance with the New ETSI PSD Requirement |
| T7288 | CEPT/E1 Line Interface(CEPT/E1 線接口) |
| T7290A | DS1/T1/CEPT/E1 Line Interface(DS1/T1/CEPT/E1 線接口) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T7234A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Compliance with the New ETSI PSD Requirement |
| T7237 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Compliance with the New ETSI PSD Requirement |
| T7237A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Compliance with the New ETSI PSD Requirement |
| T7240 | 制造商:TE Connectivity 功能描述: |
| T7-241A5 | 功能描述:撥動開關 ON NONE OFF 2 Pole Standard Bat Handle RoHS:否 制造商:OTTO 觸點形式: 開關功能: 電流額定值: 電壓額定值 AC: 電壓額定值 DC: 功率額定值: 端接類型: 安裝風格: 端子密封: 觸點電鍍: 照明: |
發布緊急采購，3分鐘左右您將得到回復。