參數資料
型號： SI3211PPTX-EVB
廠商： Silicon Laboratories Inc
文件頁數： 80/148頁
文件大小： 0K
描述： BOARD EVAL W/DISCRETE INTERFACE
標準包裝： 1
系列： ProSLIC®
主要目的： 接口，模擬前端（AFE）
已用 IC / 零件： Si3211
已供物品： 板，CD
Si3210/Si3211
Rev. 1.61
37
Not
Recommended
fo
ew
D
esi
gn
s
boost dc-dc converter that converts a positive dc
voltage into the desired negative battery voltage. In
addition to eliminating external power supplies, this
allows the Si3210 to dynamically control the battery
voltage to the minimum required for any given mode of
operation.
Two different dc-dc circuit options are offered: a BJT/
inductor version and a MOSFET/transformer version.
Due to the differences on the driving circuits, there are
two different versions of the Si3210. The Si3210
supports the BJT/inductor circuit option, and the
Si3210M version supports the MOSFET solution. The
only difference between the two versions is the polarity
of the DCFF pin with respect to the DCDRV pin. For the
Si3210, DCDRV and DCFF are of opposite polarity. For
the Si3210M, DCDRV and DCFF are the same polarity.
Table 27 summarizes these differences.
Extensive design guidance on each of these circuits can
be obtained from “AN45: Design Guide for the Si3210
DC-DC Converter” and from an interactive dc-dc
converter design spreadsheet. Both of these documents
are available on the Silicon Laboratories website
(www.silabs.com).
2.2.2. BJT/Inductor Circuit Option Using Si3210
The BJT/Inductor circuit option shown in Figure 10 on
page 18 offers a flexible, low-cost solution. Depending
on selected L1 inductance value and the switching
frequency, the input voltage (VDC) can range from 5 V to
30 V. Because of the nature of a dc-dc converter’s
operation, peak and average input currents can become
large with small input voltages. Consider this when
selecting the appropriate input voltage and power rating
for the VDC power supply.
For this solution, a PNP power BJT (Q7) switches the
current flow through low ESR inductor L1. The Si3210
uses the DCDRV and DCFF pins to switch Q7 on and
off. DCDRV controls Q7 through NPN BJT Q8. DCFF is
ac-coupled to Q7 through capacitor C10 to assist R16 in
turning off Q7. Therefore, DCFF must have opposite
polarity to DCDRV, and the Si3210 (not Si3210M) must
be used.
Table 27. Si3210 and Si3210M Differences
Device
DCFF Signal
Polarity
DCPOL
Si3210
= DCDRV
0
Si3210M
= DCDRV
1
Notes:
1. DCFF signal polarity with respect to DCDRV signal.
2. Direct Register 93, bit 5; This is a read-only bit.
相關PDF資料
PDF描述
ECM28DCCI CONN EDGECARD 56POS R/A .156 SLD
SI3216DCQ1-EVB DAUGHTER CARD W/SI3201 INTERFACE
ECM28DCAI CONN EDGECARD 56POS R/A .156 SLD
SI3050DC1-EVB DAUGHTERCARD DAA SI3050/SI3018
SI3216DCQX-EVB DAUGHTER CARD W/DISCRETE INTRFC
相關代理商/技術參數
參數描述
SI3212 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3212-BT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3212-KT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3215 制造商:SILABS 制造商全稱:SILABS 功能描述:PROSLIC㈢ PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3215-B-FM 功能描述:電信線路管理 IC SINGLE CHANNEL SLIC RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*