參數資料
型號: SI3050-E1-GT
廠商: Silicon Laboratories Inc
文件頁數: 86/128頁
文件大小: 0K
描述: IC VOICE DAA SYSTEM SIDE 24QFN
標準包裝: 74
系列: *
Si3050 + Si3011/18/19
60
Rev. 1.5
CIR1: OH
Data that is received must be consistent and match for at least two consecutive frames to be considered valid.
When a new command or status is communicated via the C/I bits, the data must be sent for at least two
consecutive frames to be recognized by the Si3050. The following steps describe the protocol of how C/I bits are
stored, detected, and validated. This is illustrated in Figure 49.
1. The current state of the C/I bits are stored in a primary register P. If the received C/I bits are identical to this
current state, no action is taken.
2. Upon receipt of an SC channel with C/I bits that differ from the current state, these new C/I bits are immediately
latched into a secondary register S.
3. The C/I bits in the SC channel received in the frame immediately after the SC channel just stored in S are
compared with the C/I bits in the S register.
a. If the C/I bits in these two channels are identical, then the C/I bits in the S register are loaded into the P
register and are considered a valid change of C/I bits. The Si3050 then responds accordingly to the changed
C/I bits.
b. If a set of C/I bits is latched into the S register and the subsequent set of C/I bits received does not match
either the S or P registers, then the newly received set of C/I bits are latched into the S register. This
continues to occur as long as the subsequent set of C/I bits received differs from the C/I bits in the S and
Pregisters.
c. If the C/I bits in the SC channel received immediately after the SC channel just stored in S do not match the
C/I bits stored in S, but DO match the C/I bits stored in P, then the single set of C/I bits stored in the S latch
are invalidated, and the current state of the C/I bits in P remains unchanged.
Figure 49. Protocol for Receiving C/I Bits in the Si3050
Receive New
CI Code
Store in S
Receive New
C/I Code
= P?
= S?
Load C/I Register
With New C/I Bits
Yes
No
Yes
No
P: C/I Primary Register Contents
S: C/I Secondary Register Contents
相關PDF資料
PDF描述
VE-2NM-IX-F4 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F3 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F2 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F1 CONVERTER MOD DC/DC 10V 75W
VE-2NL-IX-F4 CONVERTER MOD DC/DC 28V 75W
相關代理商/技術參數
參數描述
SI3050-E1-GTR 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side
Si3050-E-FM 功能描述:電信語音調制 IC Si3050 Voice DAA System-Side RoHS:否 制造商:Epson Electronics America 產品: 應用:Voice Guidance product 封裝 / 箱體:PQFP-52 電源電壓-最大:3.6 V, 5.5 V 最大工作溫度: 最小工作溫度: 封裝:
SI3050-E-FMR 功能描述:電信線路管理 IC Si3050 Voice DAA System-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3050-E-FS 制造商:SILABS 制造商全稱:SILABS 功能描述:GLOBAL VOICE DAA
SI3050-E-FSR 制造商:SILABS 制造商全稱:SILABS 功能描述:PCM highway data interface law A-law companding SPI control interface GCl interface