- 您現在的位置：買賣IC網 > PDF目錄10909 > SI3050-E1-GT (Silicon Laboratories Inc)IC VOICE DAA SYSTEM SIDE 24QFN PDF資料下載
參數資料
| 型號： | SI3050-E1-GT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 77/128頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC VOICE DAA SYSTEM SIDE 24QFN |
| 標準包裝： | 74 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁當前第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
Si3050 + Si3011/18/19
52
Rev. 1.5
Figure 44. Monitor Handshake Timing
The Idle state is achieved by the MX and MR bits being held inactive (signal is high) for two or more frames. When
a transmission is initiated by a host device, an active state (signal is low) is present on the downstream MX bit. This
signals to the Si3050 that a transmission has begun on the Monitor channel and the Si3050 should begin accepting
data from host device. The Si3050, after reading the data on the Monitor channel, acknowledges the initial
transmission by placing the upstream MR bit in an active state. The data is received and the upstream MR
becomes active in the frame immediately following the downstream MX becoming active. The upstream MR then
remains active until either the next byte is received or an end of message is detected. The end of message is
signaled by the downstream MX being held inactive for two or more consecutive frames. Receipt of initial data is
signaled by the upstream MR bit’s transitioning from an inactive to an active state. Upon receiving
acknowledgement from the Si3050 that the initial data is received, the host device places the downstream MX bit in
the inactive state for one frame and then either transmit another byte by placing the downstream MX bit in an active
state again, or signal an end of message by leaving the downstream MX bit inactive for a second frame.
When the host is performing a write command, the host only manipulates the downstream MX bit, and the Si3050
only manipulates the upstream MR bit. If a read command is performed, the host initially manipulates the
downstream MX bit to communicate the command, but then manipulates the downstream MR bit in response to the
Si3050 responding with the requested data. Similarly, the Si3050 initially manipulates its upstream MR bit to
receive the read command, and then manipulates its upstream MX bit to respond with the requested data. If the
host is transmitting data, the Si3050 always transmits a $FF value on its Monitor data byte. While the Si3050 is
transmitting data, the host should always transmit a $FF value on its Monitor byte. If the Si3050 is transmitting data
and detects a value other than a $FF on the downstream Monitor byte, the Si3050 signals an Abort.
For read and write commands, an initial address must be specified. The Si3050 responds to a read or a write
command at this address, and then subsequently increment this address after every register access.
Transm itter
Receiver
1st Byte
2nd Byte
3rd Byte
MX
MR
ACK
1st Byte
ACK
2nd Byte
ACK
3rd Byte
125 s
MR
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2NM-IX-F4 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F3 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F2 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F1 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NL-IX-F4 | CONVERTER MOD DC/DC 28V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3050-E1-GTR | 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side |
| Si3050-E-FM | 功能描述:電信語音調制 IC Si3050 Voice DAA System-Side RoHS:否 制造商:Epson Electronics America 產品: 應用:Voice Guidance product 封裝 / 箱體:PQFP-52 電源電壓-最大:3.6 V, 5.5 V 最大工作溫度: 最小工作溫度: 封裝: |
| SI3050-E-FMR | 功能描述:電信線路管理 IC Si3050 Voice DAA System-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| SI3050-E-FS | 制造商:SILABS 制造商全稱:SILABS 功能描述:GLOBAL VOICE DAA |
| SI3050-E-FSR | 制造商:SILABS 制造商全稱:SILABS 功能描述:PCM highway data interface law A-law companding SPI control interface GCl interface |
發布緊急采購，3分鐘左右您將得到回復。