466
32072H–AVR32–10/2012
AT32UC3A3
SMBPECERR: SMBus PEC Error
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when a SMBus PEC error has occurred.
SMBTOUT: SMBus Timeout
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when a SMBus timeout has occurred.
NAK: NAK Received
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when a NAK was received from the master during slave transmitter operation.
ORUN: Overrun
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when an overrun has occurred in slave receiver mode. Can only occur if CR.STREN is zero.
URUN: Underrun
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when an underrun has occurred in slave transmitter mode. Can only occur if CR.STREN is zero.
TRA: Transmitter Mode
0: The slave is in slave receiver mode.
1: The slave is in slave transmitter mode.
TCOMP: Transmission Complete
This bit is cleared when the corresponding bit in SCR is written to one.
This bit is set when transmission is complete. Set after receiving a STOP after being addressed.
SEN: Slave Enabled
0: The slave interface is disabled.
1: The slave interface is enabled.
TXRDY: TX Buffer Ready
0: The TX buffer is full and should not be written to.
1: The TX buffer is empty, and can accept new data.
RXRDY: RX Buffer Ready
0: No RX data ready in RHR.
1: RX data is ready to be read from RHR.