- 您現在的位置：買賣IC網 > PDF目錄385768 > RF2469 (RF MICRO DEVICES INC) W-CDMA AND PCS LOW NOISE AMPLIFIER/MIXER DOWNCONVERTER PDF資料下載
參數資料
| 型號： | RF2469 |
| 廠商： | RF MICRO DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | W-CDMA AND PCS LOW NOISE AMPLIFIER/MIXER DOWNCONVERTER |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, QCC20 |
| 封裝： | 4 X 4 MM, LCC-20 |
| 文件頁數： | 9/18頁 |
| 文件大小： | 255K |
| 代理商： | RF2469 |
Preliminary
8-41
RF2469
Rev A5 010717
8
F
LNA P1dB Compression Point
For large signal input, this type of LNA will not have a fixed DC bias current. The LNA will tend to self-bias when the input
signal level starts increasing above small signal conditions. This particular characteristic will move the DC bias current to
a higher DC bias current. Obviously, increasing the bias current will increase the linearity of the LNA.
To accurately measure the P1dB, the measurement technique must force the bias current in the LNA to be a constant,
while preserving the collector output voltage of the LNA. In order to due this, a separate supply voltage must be used for
the bias voltage of the LNA (pin 3) and the open collector supply (pin 1). As the input signal level is increased, the bias
voltage must be dropped while monitoring the DC current in the LNA to ensure that it remains constant. Incidentally, the
P1dB compression measured with this technique is consistent with the standard approximation relating P1dB to IIP3
(i.e., Input P1dB=IIP3(dBm)-10). Since the IIP3 measurements are done under small signal conditions (the input tones
are low power levels), this approximation provides a good figure for P1dB under a constant DC bias condition. For the
RF2469, with an IIP3 of approximately +8dBm, the Input P1dB is approximately -2dBm.
However, for many applications, forcing the bias current in the LNA to be constant is not a practical solution. Leaving the
LNA to self-bias will not produce any damage to the part and the P1dB performance under this condition will be:
Frequency
(MHz)
2140
Gain
(dB)
10.5
Input
P1dB
5.25
Output
P1dB
14.92
LNA Current
(mA)
~23
相關PDF資料 |
PDF描述 |
|---|---|
| RF2472 | 2.4GHZ LOW NOISE AMPLIFIER WITH ENABLE |
| RF2475 | DUAL-BAND LOW NOISE AMPLIFIER/MIXER WITH FREQUENCY DOUBLER |
| RF2480 | DIRECT QUADRATURE MODULATOR |
| RF2483 | LOW NOISE DUAL-BAND QUADRATURE MODULATOR WITH AGC |
| RF2484 | DIRECT QUADRATURE MODULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2471-000 | 功能描述:可復位保險絲 RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C |
| RF2472 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:2.4GHZ LOW NOISE AMPLIFIER WITH ENABLE |
| RF2472_06 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:2.4GHz LOW NOISE AMPLIFIER WITH ENABLE |
| RF2472_1 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:2.4GHz LOW NOISE AMPLIFIER WITH ENABLE |
| RF2472G | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:2.4GHz LOW NOISE AMPLIFIER WITH ENABLE |
發布緊急采購，3分鐘左右您將得到回復。