- 您現在的位置：買賣IC網 > PDF目錄368020 > PI7C8150A PCI Bridge | 2-Port PCI-to-PCI Bridge PDF資料下載
參數資料
| 型號： | PI7C8150A |
| 英文描述： | PCI Bridge | 2-Port PCI-to-PCI Bridge |
| 中文描述： | PCI橋| 2端口PCI至PCI橋 |
| 文件頁數： | 70/115頁 |
| 文件大?。?/td> | 879K |
| 代理商： | PI7C8150A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁當前第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
PI7C8150B
2-PORT PCI-TO-PCI BRIDGE
ADVANCE INFORMATION
Page 70 of 115
July 31, 2003 – Revision 1.031
8.2.1
SECONDARY BUS ARBITRATION USING THE INTERNAL
ARBITER
To use the internal arbiter, the secondary bus arbiter enable pin, S_CFN_L, must be tied
LOW. PI7C8150B has nine secondary bus request input pins, S_REQ_L[8:0], and has nine
secondary bus output grant pins, S_GNT_L[8:0], to support external secondary bus
masters.
The secondary bus request and grant signals are connected internally to the arbiter and are
not brought out to external pins when S_CFN_L is HIGH.
Figure 8-1 Secondary Arbiter Example
The secondary arbiter supports a 2-sets programmable 2-level rotating algorithm with each
set taking care of 9 requests / grants. Each set of masters can be assigned to a high priority
group and a low priority group. The low priority group as a whole represents one entry in
the high priority group; that is, if the high priority group consists of n masters, then in at
least every n+1 transactions the highest priority is assigned to the low priority group.
Priority rotates evenly among the low priority group. Therefore, members of the high
priority group can be serviced n transactions out of n+1, while one member of the low
priority group is serviced once every n+1 transactions. Figure 9–1 shows an example of an
internal arbiter where four masters, including PI7C8150B, are in the high priority group,
and five masters are in the low priority group. Using this example, if all requests are always
asserted, the highest priority rotates among the masters in the following fashion (high
priority members are given in italics, low priority members, in boldface type):
B, m0, m1,
m2,
m3
, B, m0, m1, m2,
m4
, B, m0, m1, m2,
m5
, B, m0, m1, m2,
m6
, B, m0, m1, m2,
m7
and so on.
Each bus master, including PI7C8150B, can be configured to be in either the low priority
group or the high priority group by setting the corresponding priority bit in the arbiter-
control register. The arbiter-control register is located at offset 40h. Each master has a
corresponding bit. If the bit is set to 1, the master is assigned to the high priority group. If
the bit is set to 0, the master is assigned to the low priority group. If all the masters are
assigned to one group, the algorithm defaults to a straight rotating priority among all the
masters. After reset, all external masters are assigned to the low priority group, and
PI7C8150B is assigned to the high priority group. PI7C8150B receives highest priority on
the target bus every other transaction and priority rotates evenly among the other masters.
Priorities are re-evaluated every time S_FRAME_L is asserted at the start of each new
transaction on the secondary PCI bus. From this point until the time that the next
transaction starts, the arbiter asserts the grant signal corresponding to the highest priority
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C8150A-33 | PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150B | PCI Bridge | Asynchronous 2-Port PCI Bridge |
| PI7C8152A | ENHANCED 2- PORT TO PCI BRIDGE INTEL 21152 COMPORISON |
| PI7C81552 | ENHANCED 2-PORT PCI TO PCI BRIDGE INTEL 21152 COMPARISON |
| PI7C81552A | ENHANCED 2-PORT PCI TO PCI BRIDGE INTEL 21152 COMPARISON |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C8150A-33 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150AMA | 制造商:Pericom Semiconductor Corporation 功能描述:PCI to PCI Bridge 208-Pin FQFP |
| PI7C8150AMA-33 | 制造商:Pericom Semiconductor Corporation 功能描述:PCI-to-PCI Bridge 208-Pin FQFP |
| PI7C8150AMAE | 功能描述:外圍驅動器與原件 - PCI 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PI7C8150AMAE-33 | 功能描述:外圍驅動器與原件 - PCI 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。