- 您現在的位置：買賣IC網 > PDF目錄98050 > P95020ZLLGI (INTEGRATED DEVICE TECHNOLOGY INC) 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 PDF資料下載
參數資料
| 型號： | P95020ZLLGI |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 電源管理 |
| 英文描述： | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 |
| 封裝： | LLGA-124 |
| 文件頁數： | 137/137頁 |
| 文件大小： | 3533K |
| 代理商： | P95020ZLLGI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁當前第137頁
P95020 / Preliminary Datasheet
Revision 0.7.10
99
2010 Integrated Device Technology, Inc.
TSC
– MEASURING TOUCH SCREEN PRESSURE (Z1/Z2)
The user can configure whether pressure measurements will be taken by writing to the Pressure Measure Control bits in
the TSC Configuration Register. When measuring touch screen pressure, two parameters (Z1 and Z2) are measured
automatically. Along with the X/Y measurement, these values can be used to calculate the touch-resistance (RTOUCH) with
a formula such as:
1
2
4096
Z
X
R
PLATE
X
TOUCH
Where RX-PLATE is the X-plate panel resistance.
ADC
Y+
Y-
X-
X+
GND
REF-
REF+
VDD
R-touch
ADC
Y+
Y-
X-
X+
GND
REF-
REF+
VDD
R-touch
Measure Z1-Position
Measure Z2-Position
12.3.2
GENERAL PURPOSE ADC MODE
In this mode, GPIO6/7/8/9 are analog general purpose auxiliary signal inputs ADC1/ADC3/ADC2/ADC0. There are also
other four internal signals connect to ADC input multiplexer: BAT, TEMP, VSYS and ICHRG. Those signals are for battery
voltage, die temperature, system voltage and charging current measurement.
ADC AUTO POWER DOWN MODE
In this mode, the ADC and internal reference is usually off. When a measurement is either scheduled by internal timer or
external request, the device powers up the ADC and internal reference, and waits for the internal reference to settle. Then
the signal acquisition starts. The ADC and the reference will be powered down after all the outstanding
scheduled/requested tasks are finished. All the measurement channels will be served in a round robin manner.
ADC ALWAYS ON MODE
In this mode, the ADC is always powered up and the internal ADC reference is always on. The internal reference remains
fully powered after completing a sequence. All the measurement channels will be served in a round robin manner.
12.3.3
SYSTEM MONITORING AND ALERT GENERATION
There are four internal channels support scheduled measurement and monitoring:
Battery voltage (VBAT) measurement
Die Temperature (VTEMP) measurement
Vsys Level (VSYS) measurement
Battery charging current (CHRG_ICHRG) measurement
Among those, three of them are with alert signal generation:
Battery voltage
Die temperature
Vsys level
Measured results are saved in dedicated result registers and compared with pre-defined spec limits. If it is out of the limit,
an alert (map to processor interrupt) signal can be asserted and alert status will be set.
相關PDF資料 |
PDF描述 |
|---|---|
| P95020ZNQGI | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132 |
| P95020ZNQG | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132 |
| P95020ZLLG8 | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 |
| P95020ZLLGI8 | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 |
| PBL3717A | STEPPER MOTOR CONTROLLER, 1.2 A, PDIP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P95021NQG | 功能描述:PMIC 解決方案 Integrates Audio, LED B/Light Pwr Mgt RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| P95021NQG8 | 制造商:Integrated Device Technology Inc 功能描述:POWER MANAGEMENT, AUDIO & CONT 制造商:Integrated Device Technology Inc 功能描述:132-VFQFPN - Tape and Reel 制造商:Integrated Device Technology Inc 功能描述:Integrates Audio, LED B/Light Pwr Mgt |
| P950-36I | 制造商:Tripp Lite 功能描述:SERIAL ATA II SIGNAL CABLE, 2X7-PIN STRAIGHT CONNECTOR - 39" - Bulk |
| P9508- | 制造商:ROEBUCK 功能描述:ROEBUCK DISH WASHING BRUSH |
| P9-511121 | 功能描述:按鈕開關 Flush Dome Solder 5A SPST-DB, SPDT-DB RoHS:否 制造商:OTTO 觸點形式: 開關功能: 電流額定值: 電壓額定值 AC: 電壓額定值 DC: 功率額定值: 安裝風格: 照明: 照明顏色: IP 等級: 端接類型: 觸點電鍍: 執行器: 蓋顏色: 封裝: 可燃性等級: |
發布緊急采購，3分鐘左右您將得到回復。