- 您現在的位置：買賣IC網 > PDF目錄367732 > P80CE598 (NXP Semiconductors N.V.) 8-bit microcontroller with on-chip CAN PDF資料下載
參數資料
| 型號： | P80CE598 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 8-bit microcontroller with on-chip CAN |
| 中文描述： | 8位微控制器芯片的CAN |
| 文件頁數： | 55/108頁 |
| 文件大?。?/td> | 507K |
| 代理商： | P80CE598 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁當前第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
1996 Jun 27
55
Philips Semiconductors
Product specification
8-bit microcontroller with on-chip CAN
P8xCE598
13.5.20.1 Synchronization Rules
The synchronization rules are as follows:
Only one synchronization within one bit time is used.
An edge is used for synchronization only if the value
detected at the previous sample point differs from the
bus value immediately after the edge.
Hard synchronization is performed whenever there is a
recessive-to-dominant edge during Bus-Idle
(see Section 13.6.6).
All other edges (recessive-to-dominant and optionally
dominant-to recessive edges if the Sync bit is set HIGH
(see Section 13.5.3) which are candidates for
resynchronization will be used with the following
exception:
– A transmitting CAN-controller will not perform a
resynchronization as a result of a
recessive-to-dominant edge with positive phase
error, if only these edges are used for
resynchronization. This ensures that the delay times
of the output driver and input comparator do not
cause a permanent increase in the bit time.
13.6
CAN 2.0A Protocol description
13.6.1
F
RAME TYPES
The P8xCE598's CAN-controller supports the four
different CAN-protocol frame types for communication:
Data Frame, to transfer data
Remote Frame, request for data
Error Frame, globally signal a (locally) detected error
condition
Overload Frame, to extend delay time of subsequent
frames (an Overload Frame is not initiated by the
P8xCE598 CAN-Controller).
13.6.1.1
Bit representation
There are two logical bit representations used in the
CAN-protocol:
A recessive bit on the bus-line appears only if all
connected CAN-controllers send a recessive bit at that
moment.
Dominant bits always overwrite recessive bits i.e. the
resulting bit level on the bus-line is dominant.
13.6.2
D
ATA
F
RAME
A Data Frame carries data from a transmitting
CAN-controller to one or more receiving ones.
A Data Frame is composed of seven different bit-fields:
Start-Of-Frame
Arbitration Field
Control Field
Data Field (may have a length of zero)
CRC Field
Acknowledge Field
End-Of-Frame.
13.6.2.1
Start-Of-Frame bit
Signals the start of a Data Frame or Remote Frame.
It consists of a single dominant bit use for hard
synchronization of a CAN-controller in receive mode.
13.6.2.2
Arbitration Field
Consists of the message Identifier and the RTR bit. In the
case of simultaneous message transmissions by two or
more CAN-controllers the bus access conflict is solved by
bit-wise arbitration, which is active during the transmission
of the Arbitration Field.
13.6.2.3
Identifier
This 11-bit field is used to provide information about the
message, as well as the bus access priority. It is
transmitted in the order ID.10 to ID.0 (LSB). The situation
that the seven most significant bits (ID.10 to ID.4) are all
recessive must not occur.
An Identifier does not define which particular
CAN-controller will receive the frame because a CAN
based communication network does not differentiate
between a point-to-point, multicast or broadcast
communication.
相關PDF資料 |
PDF描述 |
|---|---|
| P83CL781 | Low voltage 8-bit microcontrollers with UART and I2C-bus |
| P83CL781HFH | Low voltage 8-bit microcontrollers with UART and I2C-bus |
| P83CL781HFP | Low voltage 8-bit microcontrollers with UART and I2C-bus |
| P83CL782 | Low voltage 8-bit microcontrollers with UART and I2C-bus |
| P83CL782HDH | Low voltage 8-bit microcontrollers with UART and I2C-bus |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P80CE598FFB | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P80CE598FFB/00,518 | 功能描述:8位微控制器 -MCU 8B MCU ON-CHIP CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P80CE598FFB/00,557 | 功能描述:8位微控制器 -MCU 8B MCU ON-CHIP CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P80CE598FFB/00551 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC-SM-8-BIT MCU+CAN |
| P80CE598FHB | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
發布緊急采購，3分鐘左右您將得到回復。