- 您現在的位置：買賣IC網 > PDF目錄380581 > MX97103FC (MACRONIX INTERNATIONAL CO LTD) ISDN S/T-PCI TRANSCEIVER PDF資料下載
參數資料
| 型號： | MX97103FC |
| 廠商： | MACRONIX INTERNATIONAL CO LTD |
| 元件分類： | 通信及網絡 |
| 英文描述： | ISDN S/T-PCI TRANSCEIVER |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP100 |
| 封裝： | PLASTIC, QFP-100 |
| 文件頁數： | 1/13頁 |
| 文件大?。?/td> | 82K |
| 代理商： | MX97103FC |
1
P/N:PM0564
REV. 1.0, FEB. 23, 1999
MX97103
ISDN S/T-PCI TRANSCEIVER
PRELIMINARY
GENERAL DESCRIPTION
MX97103 is a single chip solution for ISDN-S connec-
tion on PCI bus. It integrates S-transceiver, D and B
channel protocol controllers, and PCI interface.
It can be divided into the following major functional blocks
: analog front end, layer 1 function, GCI interface. LAPD
controller, B channel HDLC controllers, EEPROM inter-
face and PCI interface. The important function of each
major block will be described below.
According to ITU 1.430 spec. the S/T interface is a 4-
wire interface. Among them, 2 wires are used for trans-
mitting, and the other two are for receiving. The wiring
configurations include short passive bus, extended pas-
sive bus and point-to-point connection. For short pas-
sive bus, the operation distance is from 100m to 200m,
and the TEs(max 8)can be connected at random points
along the full length of the cable. For extended passive
bus, TEs connect to the cable at the far end from the NT.
The total length would be at least 500m and a differen-
tial distance between TE connection points is of 25 to
50m. For point-to-point connection, the cable length can
be 1km.
The analog front end deals with the signals transmitted
to and received from the wiring cable. It accepts the
digital data from layer 1 block and converts them into
appropriate signals to be sent out to the wire, and it also
receive the attenuated and distorted signal from the wire
and recover them to be processed by layer 1 block.
FEATURE
Single chip solution for ISDN PC card with PCI inter-
face
Supports full duplex 2B+D ISDN S/T transceiver ac-
cording to ITU I.430
Integrate S-interface, D & B channel protocol control-
lers, and PCI controller
32-bit PCI bus interface
Each B channel has 2x64 byte FIFO for each direction
D channel has 2x32 byte FIFO for each direction
EEPROM interface for loading vendor-specific data
One programmable LED
Comply to ACPI Rev 1.0
0.5u CMOS
100-pin PQFP package
The layer 1 block comprises of PDLL, DAC, RT and MFC
functions. DPLL's function is to establish S/T frame syn-
chronization. DAC resolves the contention issue for
differnet TE accessing D channel at the same time. RT
deals with the receiving S/T data extraction and put out
the transmitted data at the corrent time slot. MFC is the
multiframing S and Q channel control block.
GCI is the digital bus for the IC. It can accomodate 8
GCI-compatible devices. This block converts the frame
between GCI and S/T interface.
LAPD block relieves the microprocessor of the duty to
generate HDLC frame on the D channel. It can gener-
ate flag, CRC, address and control field automatically.
And it can generate S-frame for HDLC protocol. It con-
tains 2 FIFO of 2x32 byte each to facilitate the D packet
transmission and reception.
Two B channel HDLC controllers can handle tasks like
flag and CRC generation, zero insertion and deletion.
For each direction a 2x64 byte FIFO is provided to buffer
the data.
The EEPROM interface is used to load specific vendor
information after system hardware reset. Vendor ID and
device ID can be load to distinguish different products.
If EEPROM is not used, default values will be set.
The PCI interface enables the chip attached to PCI bus
directly without any glue logic. The bus speed can be
from 25MHz to 33MHz.
相關PDF資料 |
PDF描述 |
|---|---|
| MX98206EC | 8-Port Dual-Speed Ethernet Switch Controller(8端口、雙速以太網開關控制器) |
| MX98206 | 8-Port Dual-Speed Ethernet Switch Controller(8端口、雙速以太網開關控制器) |
| MX98207AC | 12-Port Dual-Speed Ethernet Switch Controller(12端口、雙速以太網開關控制器) |
| MX98207 | 12-Port Dual-Speed Ethernet Switch Controller(12端口、雙速以太網開關控制器) |
| MX98224EC | 24-port Dual-Speed Ethernet Switch Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MX98224EC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-port Dual-Speed Ethernet Switch Controller |
| MX98702 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Transceiver |
| MX98704 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:100BASE-TX PHYSICAL DATA TRANSCEIVER |
| MX98704EC | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:100BASE-TX PHYSICAL DATA TRANSCEIVER |
| MX98704QC | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:100BASE-TX PHYSICAL DATA TRANSCEIVER |
發(fā)布緊急采購，3分鐘左右您將得到回復。