參數資料
型號： MC68HC705V8CFU
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 微控制器/微處理器
英文描述： 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQFP64
封裝： QFP-64
文件頁數： 27/172頁
文件大?。?/td> 890K
代理商： MC68HC705V8CFU
SECTION 15: MESSAGE DATA LINK CONTROLLER
MOTOROLA
Page 111
MC68HC705V8 Specification Rev. 2.1
If the received message is verified as error-free then the CRC is discarded, the filled Rx
Buffer and the final value of the Rx Buffer pointer are placed into the CPU’s memory map,
the Received Message Successfully (RXMS) bit in the MDLC Status Register (MSR) is set,
a CPU interrupt request is made (if interrupts are enabled) and the other Rx Buffer and its
pointer are readied for reception of the next message by the MDLC.
The CPU may now randomly read the Rx Buffer. The first data byte received will be located
in the lowest address entry of the Rx Buffer. The rest of the message is located in
contiguous ascending address entries up to the last data byte received, which will be
located in the nth entry, where ’n’ is the final value of the Rx Buffer pointer which now
appears in the MDLC Rx Status Register (MRSR).
As long as the CPU has possession of this Rx Buffer, the MDLC will have possession of
the other Rx Buffer and can concurrently receive a second message without conflict with,
or intervention by, the CPU. Once the CPU has finished with the contents of the Rx Buffer,
it may be "given back" to the MDLC by writing any value to the MRSR register.
The above sequence is then repeated as long as normal data reception takes place.
If the CPU is unable to return an Rx Buffer and the second Rx Buffer becomes filled and a
further new message arrives from the J1850 bus then the new message will be ignored by
the MDLC until an Rx Buffer becomes available to receive new data.
If any type of reception error is detected by the MDLC as a message is being received from
the J1850 bus, the internal Rx Buffer pointer will be reset to zero, effectively flushing the
data received so far, and the MDLC will ignore the rest of the message. When this occurs
the MDLC will not generate a CPU interrupt request and will silently wait for the next valid
SOF symbol.
This will also happen if a message received from the J1850 bus is longer than 12 bytes
(including CRC byte), and the Receive Block mode (RXBM) bit is not set. In both cases,
when the internal Rx Buffer pointer is reset to zero, the associated Rx Buffer array bytes
will not be cleared or changed.
If a message received from the J1850 bus is longer than 12 bytes (including CRC byte),
and the Receive Block mode (RXBM) bit is set then reception of the message will be
continued into the next available Rx Buffer. This will repeat until the end of the message is
detected, at which time the residual data bytes will remain in the last Rx Buffer to be filled.
15.3.3
TX BUFFER
The Tx Buffer consists of one 11-byte array, with 8 bits per byte. Only one message may
occupy the Tx Buffer at any time. The Tx Buffer array has an internal register (the ’Tx Buffer
pointer’) associated with it in which the length of the message body is stored.
Following a reset, the CPU has "possession" of the empty Tx Buffer and its associated Tx
Buffer pointer is reset to zero. The Tx Buffer appears in the CPU’s memory map at this time,
where the CPU may randomly access it. The first data byte of the message to be sent must
be placed in the lowest address entry of the Tx Buffer. The rest of the message must be
placed in contiguous ascending address entries up to the last data byte to be sent, which
is located in the nth entry, where ’n’ is the length of the message body to be sent.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC68HC705V8B 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP56
MC68HC705V8FN 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQCC68
MC68HC705V8CFN 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQCC68
MC68HC705X4CDW 8-BIT, OTPROM, 2.2 MHz, MICROCONTROLLER, PDSO28
MC68HC05X4CDW 8-BIT, MROM, 2.2 MHz, MICROCONTROLLER, PDSO28
相關代理商/技術參數
參數描述
MC68HC706P6ACDW 制造商:Motorola Inc 功能描述:
MC68HC708MP16CFU 制造商:MAJOR 功能描述:
MC68HC711D3CFBE2 制造商:Freescale Semiconductor 功能描述:
MC68HC711D3CFN2 功能描述:IC MCU 2MHZ 4K OTP 44-PLCC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC11 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C，IrDA，LIN，SPI，UART/USART 外圍設備:DMA，PDR，POR，PVD，PWM，溫度傳感器，WDT 輸入/輸出數:26 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN，36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND
MC68HC711D3CFNE2 功能描述:8位微控制器 -MCU 8B OTP 192RAM 2 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*