- 您現在的位置：買賣IC網 > PDF目錄45038 > M37906M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 PDF資料下載
參數資料
| 型號： | M37906M8C-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| 封裝： | 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42 |
| 文件頁數： | 73/99頁 |
| 文件大?。?/td> | 1313K |
| 代理商： | M37906M8C-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁當前第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
98
8168C-MCU Wireless-02/10
AT86RF212
The BBP performs further filtering and signal processing. In RX_ON state, the receiver
searches for the synchronization header. Once the synchronization is established and
the SFD is found, the received signal is demodulated and provided to the Frame Buffer.
The receiver performs a state change indicated by register bits TRX_STATUS (register
0x01, TRX_STATUS) to BUSY_RX. Once the whole frame is received, the receiver
switches back to RX_ON to listen on the channel. A similar scheme applies to the
Extended Operating Mode.
The receiver is designed to handle reference oscillator accuracies up to ±60 ppm; refer
frequency and symbol rate errors up to ±120 ppm.
Several status information are generated during the receive process: LQI, ED, and
RX_STATUS. They are automatically appended during Frame Read Access, refer to
section 4.3.2. Some information is also available through register access, e.g. ED value
(register 0x07, PHY_ED_LEVEL) and FCS correctness (register 0x06, PHY_RSSI).
The Extended Operating Mode of the AT86RF212 supports frame filtering and pending
data indication.
The frame receive procedure, including the radio transceiver setup for reception and
reading PSDU data from the Frame Buffer, is described in section 8.1.
7.2.2 Configuration
In Basic Operating Mode, the receiver is enabled by writing command RX_ON to
register bits TRX_CMD (register 0x02, TRX_STATE) in states TRX_OFF or PLL_ON. In
Extended Operating Mode, the receiver is enabled for RX_AACK operation from state
PLL_ON by writing the command RX_AACK_ON.
There is no additional configuration required to receive IEEE 802.15.4 compliant frames
when using the Basic Operating Mode. However, the frame reception in the Extended
Operating Mode requires further register configurations. For details, refer to section
For specific applications, the receiver can be configured to handle critical environments,
to simplify the interaction with the microcontroller, or to operate different data rates.
The AT86RF212 receiver has an outstanding sensitivity performance. At certain
conditions (interference floor, High Data Rate Modes, refer to section 7.1.4), it may be
useful to manually decrease this sensitivity. This is achieved by adjusting the
synchronization header detector threshold using register bits RX_PDT_LEVEL (register
0x15, RX_SYN). Received signals with a RSSI value below the threshold do not
activate the demodulation process.
Furthermore, it may be useful to protect a received frame against overwriting by
subsequent received frames. A Dynamic Frame Buffer Protection is enabled with
register bit RX_SAFE_MODE (register 0x0C, TRX_CTRL_2) set, see section 9.7. The
receiver remains in RX_ON or RX_AACK_ON state until the whole frame is uploaded
by the microcontroller, indicated by /SEL = H during the SPI Frame Receive Mode. The
Frame Buffer content is only protected if the FCS is valid.
A Static Frame Buffer Protection is enabled with register bit RX_PDT_DIS (register
0x15, RX_SYN) set. The receiver remains in RX_ON or RX_AACK_ON state and no
further SHR is detected until the register bit RX_PDT_DIS is set back.
相關PDF資料 |
PDF描述 |
|---|---|
| M37906M4H-XXXSP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
| M37906M4C-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| M37906M8C-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| M37906M6C-XXXSP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
| M37906M4C-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37906M8C-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906T-PRB | 功能描述:DEV POD PROBE FOR M37900T2-RPD-E RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF) |
| M37920FCCGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
| M37920FCCHP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
| M37920FGCGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
發布緊急采購，3分鐘左右您將得到回復。