參數資料
型號: M37905M8C-XXXSP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP64
封裝: 0.750 INCH, 1.78 MM PITCH, PLASTIC, SDIP-64
文件頁數: 24/103頁
文件大?。?/td> 1402K
代理商: M37905M8C-XXXSP
26
M37905M4C-XXXFP, M37905M4C-XXXSP
M37905M6C-XXXFP, M37905M6C-XXXSP
M37905M8C-XXXFP, M37905M8C-XXXSP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
16-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
TIMER
There are eight 16-bit timers. They are divided by type into timer A
(10) and timer B (3).
The timer I/O pins are multiplexed with I/O pins for ports P2, P4, P5
and P6. To use these pins as timer input pins, the port direction reg-
ister bit corresponding to the pin must be cleared to “0” to specify
input mode.
TIMER A
Figure 18 shows a block diagram of timer A.
Timer A has four modes: timer mode, event counter mode, one-shot
pulse mode, and pulse width modulation mode. The mode is se-
lected with bits 0 and 1 of the timer Ai mode register (i = 0 to 9). Each
of these modes is described below.
Figure 19 shows the bit configuration of the timer A clock division se-
lect register. Timers A0 to A9 use the count source which has been
selected by bits 0 and 1 of this register.
(1) Timer mode [00]
Figure 20 shows the bit configuration of the timer Ai mode register in
the timer mode. Bits 0, 1 and 5 of the timer Ai mode register must be
“0” in timer mode. The timer A’s count source is selected by bits 6
and 7 of the timer Ai mode register and the contents of the timer A
clock division select register. (See Table 7.)
The counting of the selected clock starts when the count start bit is
“1” and stops when it is “0”.
Figure 21 shows the bit configuration of the count start bit. The
counter is decremented, an interrupt is caused and the interrupt re-
quest bit in the timer Ai interrupt control register is set when the con-
tents becomes 000016. At the same time, the contents of the reload
register is transferred to the counter and count is continued.
Fig. 18 Block diagram of timer A
Timer
One-shot pulse
Pulse width
Count start registers 0, 1
(Addresses 4016, 4116)
Countdown
Data bus (odd)
Data bus (even)
Reload register(16)
Counter (16)
(Low-order 8 bits)
(High-order 8 bits)
“Countdown” is always
selected when not in the
event counter mode.
Timer A0 4716 4616
Timer A1 4916 4816
Timer A2 4B16 4A16
Timer A3 4D16 4C16
Timer A4 4F16 4E16
Countup/Countdown switching
Toggle flip-flop
Up-down registers 0, 1
(Addresses 4416, C416)
Polarity
selection
Addresses
External trigger
Event counter
TAiIN
(i = 0–9)
TAiOUT
(i = 0–9)
Timer (gate function)
Count source
select bits
Pulse output
f1
f2
f16
f64
f512
f4096
Timer A clock
division select bit
Timer A5 C716 C616
Timer A6 C916 C816
Timer A7 CB16 CA16
Timer A8 CD16 CC16
Timer A9 CF16 CE16
Addresses
相關PDF資料
PDF描述
M37905M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
M37905M6C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP64
M37906M4H-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M6C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
相關代理商/技術參數
參數描述
M37905T-PRB 功能描述:DEV POD PROBE FOR M37900T2-RPD-E RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF)
M37906F8CFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16-BIT CMOS MICROCOMPUTER
M37906F8CFP-T4 制造商:Renesas Electronics Corporation 功能描述:FLSH 16-BIT
M37906F8CSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M4C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER