- 您現在的位置：買賣IC網 > PDF目錄370847 > M37702M2-127FP (Mitsubishi Electric Corporation) SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER PDF資料下載
參數資料
| 型號： | M37702M2-127FP |
| 廠商： | Mitsubishi Electric Corporation |
| 英文描述： | SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| 中文描述： | 單片16位CMOS微機 |
| 文件頁數： | 10/59頁 |
| 文件大小： | 811K |
| 代理商： | M37702M2-127FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
10
MITSUBISHI MICROCOMPUTERS
M37702M2AXXXFP, M37702M2BXXXFP
M37702S1AFP, M37702S1BFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Port P2
E
ALE
Internal clock
φ
Port P2
E
ALE
A
D
A
D
A
D
D
A
D
D
A
D
D
(1)
(2)
(3)
(4)
(5)
(6)
A
D
D
A +
1
Port P2
E
ALE
Port P2
E
ALE
Port P2
E
ALE
Port P2
E
ALE
Access 2-byte
simultaneously
“L”
“L”
Access even
address 1-byte
“L”
“H”
Access odd
address 1-byte
“H”
“L”
Access
method
Signal
A
0
BHE
A : Address
D : Data
These waveforms are at the memory expansion mode and
the microprocessor mode.
A +
1
A +
1
A +
1
The bus interface unit operates using one of the waveforms (1) to
(6) shown in Figure 5. The standard waveforms are (1) and (2).
The ALE signal is used to latch only the address signal from the
multiplexed signal containing data and address.
The E signal becomes “L” when the bus interface unit reads an in-
struction code or data from memory or when it writes data to
memory. Whether to perform read or write is controlled by the R/W
signal. Read is performed when the R/W signal is “H” state and
write is performed when it is “L” state.
Waveform (1) in Figure 5 is used to access a single byte or two
bytes simultaneously. To read or write two bytes simultaneously,
the first address accessed must be even. Furthermore, when ac-
cessing an external memory area in memory expansion mode or
microprocessor mode, set the bus width selection input pin BYTE
to “L”. (external data bus width to 16 bits) The internal memory
area is always treated as 16-bit bus width regardless of BYTE.
When performing 16-bit data read or write, if the conditions for si-
multaneously accessing two bytes are not satisfied, waveform (2)
is used to access each byte one by one.
However, when prefetching the instruction code, if the address of
the instruction code is odd, waveform (1) is used, and only one
byte is read in the instruction queue buffer.
The signals A
0
and BHE in Figure 5 are used to control these
cases: 1-byte read from even address, 1-byte read from odd ad-
dress, 2-byte simultaneous read from even and odd addresses,
1-byte write to even address, 1-byte write to odd address, or 2-
byte simultaneous write to even and odd addresses. The A
0
signal
that is the address bit 0 is “L” when an even number address is
accessed. The BHE signal becomes “L” when an odd number ad-
dress is accessed.
The bit 2 of processor mode register (address 5E
16
) is the wait bit.
When this bit is set to “0”, the “L” width of E signal is 2 times as
long when accessing an external memory area in memory expan-
sion mode or microprocessor mode. However, the “L” width of E
signal is not extended when an internal memory area is accessed.
When the wait bit is “1”, the “L” width of E signal is not extended
for any access. Waveform (3) is an expansion of the “L” width of E
signal in waveform (1). Waveform (4), (5), and (6) are expansion
of each “L” width of E signal in waveform (2), first half of waveform
(2), and the last half of waveform (2) respectively.
Instruction code read, data read, and data write are described be-
low.
_
_
Fig. 5 Relationship between access method and signals A
0
and BHE
相關PDF資料 |
PDF描述 |
|---|---|
| M37702S1AFP | Single Chip 16 Bits CMOS Microcomputer(16位單片機) |
| M37702S1BFP | Single Chip 16 Bits CMOS Microcomputer(16位單片機) |
| M37702M2A | Single Chip 16 Bits CMOS Microcomputer(16位單片機) |
| M37702M2B | Single Chip 16 Bits CMOS Microcomputer(16位單片機) |
| M37702M2AXXXFP | SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37702M2A | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37702M2A-278FP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37702M2AXXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37702M2A-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37702M2BXXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。