參數資料
型號: M37640M8-XXXFP
廠商: Mitsubishi Electric Corporation
英文描述: SINGLE CHIP 8 BIT CMOS MICROCOMPUTER
中文描述: 單片微機8位CMOS
文件頁數: 33/96頁
文件大小: 1477K
代理商: M37640M8-XXXFP
33
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
1.17.2 Timer Y
Timer Y is a 16-bit timer that has a 16-bit reload latch,
and can be placed in any of four modes by setting
TYM4 and TYM5 (bits 4 and 5) (see Figure 1.34). The
desired mode is selected by modifying the values of
TYM4 and TYM5.
1.17.2.1 Read and Write Method
Read and write operations on the high and low-order
bytes of Timer Y must be performed in a specific or-
der.
Write Method
When writing to the timer, the lower order byte is
written first. This data is placed in a temporary reg-
ister that is assigned the same address as Timer
YL. Next, the high-order byte is written. Then, the
data is placed in the Timer YH reload latch and the
low-order byte is transferred from its temporary reg-
ister to the Timer YL reload latch. At this point, if the
Timer Y Data Write Control Bit (TYM0) (bit 0) is low,
the value in the Timer Y reload latch is also loaded
in Timer Y. If TYM0 is “1”, the data in the Timer Y
reload latch is loaded in Timer Y after Timer Y
underflows.
Fig. 1.34. Timer Y Mode Register (TYM)
Read Method
When reading Timer Y, the high-order byte is read
first. Reading the high-order byte causes the values
of Timer YH and Timer YL to be placed in temporary
registers that are assigned the same addresses as
Timer YH and Timer YL. The low-order byte of
Timer Y is then read from its temporary register.
This operation assures the correct reading of Timer
Y while it is counting.
1.17.2.2 Count Stop Control
If the Timer Y Count Stop Bit (TYM7) (bit 7) is set to a
“1”, Timer Y stops counting in all four modes.
Timer Mode
Count Source: /n (where n is 8, 16, 32, or 64)
In this mode, each time the timer underflows, the
corresponding timer interrupt request bit is set to a
“1”, the contents of the timer latch are loaded into
the timer, and the count down sequence begins
again.
In Timer mode, the signal TYOUT can also be
brought out on the CNTR1 pin. This is controlled by
TYM1 (bit1).
TYM0
Timer Y Data Write Control Bit (bit 0)
0: Write data in latch and timer
1: Write data in latch only
Timer Y Output Control Bit (bit 1)
0: TYOUT output disable
1: TYOUT output enable
Timer Y Frequency Division Ratio Bits (bit 3,2)
Bit 2
Bit 1
0
0:
0
1:
1
0:
1
1:
Timer Y Mode Bits (bits 5,4)
Bit 2
Bit 1
0
0: Timer Mode
0
1: Pulse period measurement mode
1
0: Event counter mode
1
1: HL pulse width measurement mode (continu-
ously measures high period and low period)
CNTR1 Polarity Select Bit (bit 6)
0: For event counter mode, clocked by rising edge
For pulse period measurement mode, falling edge detection
For CNTR1 interrupt request, falling edge active
For TYOUT, start on high output
1: For event counter mode, clocked on falling edge
For pulse period measurement mode, rising edge detection
For CNTR1 interrupt request, rising edge active
For TYOUT, start on low output
Timer Y Stop Bit (bit 7)
0: Count start
1: Count stop
TYM1
TYM3,2
divided by 8
divided by 16
divided by 32
divided by 64
TYM5,4
TYM6
TYM7
TYM7
TYM5
TYM4
TYM3
TYM2
TYM1
TYM0
MSB
7
LSB
0
Address: 0028
16
Access: R/W
Reset: 00
16
TYM6
相關PDF資料
PDF描述
M37640M8-111FP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-126FP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640E8 SINGLE-CHIP 8-BIT CMOS MICROCONTROLLER
M37641F8-XXXFP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37641F8-XXXHP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
相關代理商/技術參數
參數描述
M37641F8E8-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37641F8FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37641F8FP#U0 功能描述:IC 740 MCU FLASH 32K 80QFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:740/7600 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN,SCI,SPI 外圍設備:POR,PWM,溫度傳感器,WDT 輸入/輸出數:21 程序存儲器容量:40KB(20K x 16) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
M37641F8HP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37641F8HP#U0 功能描述:IC 740 MCU FLASH 32K 80LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:740/7600 產品培訓模塊:Graphics LCD System and PIC24 Interface Asynchronous Stimulus 標準包裝:27 系列:PIC® 24H 核心處理器:PIC 芯體尺寸:16-位 速度:40 MIP 連通性:I²C,SPI,UART/USART 外圍設備:欠壓檢測/復位,POR,PWM,WDT 輸入/輸出數:21 程序存儲器容量:12KB(4K x 24) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):3 V ~ 3.6 V 數據轉換器:A/D 10x10b/12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 包裝:管件 產品目錄頁面:648 (CN2011-ZH PDF) 配用:AC164339-ND - MODULE SKT FOR PM3 28SOICDV164033-ND - KIT START EXPLORER 16 MPLAB ICD2