- 您現在的位置：買賣IC網 > PDF目錄11595 > LTC4278IDKD#PBF (Linear Technology)IC PD IEEE 802.3AT 25.5W 32-DFN PDF資料下載
參數資料
| 型號： | LTC4278IDKD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 15/42頁 |
| 文件大小： | 0K |
| 描述： | IC PD IEEE 802.3AT 25.5W 32-DFN |
| 產品培訓模塊： | Power over Ethernet |
| 標準包裝： | 52 |
| 控制器類型： | 供電設備接口控制器（PD） |
| 接口： | IEEE 802.3af |
| 電源電壓： | 4.5 V ~ 20 V |
| 電流 - 電源： | 6.4mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 32-DFN（7x4）裸露焊盤 |
| 包裝： | 管件 |
| 產品目錄頁面： | 1338 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
LTC4278
22
4278fc
compensation circuitry. The logic block also contains
circuitry to control the special dynamic requirements of
flyback control. For more information on the basics of
current mode switcher/controllers and isolated flyback
converters see Application Note 19.
Feedback Amplifier—Pseudo DC Theory
For the following discussion, refer to the simplified
Switching Regulator Feedback Amplifier diagram (Figure
10A).Whentheprimary-sideMOSFETswitchMPturnsoff,
itsdrainvoltagerisesabovetheVPORTPrail.Flybackoccurs
when the primary MOSFET is off and the synchronous
secondary MOSFET is on. During flyback the voltage on
nondriventransformerpinsisdeterminedbythesecondary
voltage. The amplitude of this flyback pulse, as seen on
the third winding, is given as:
VFLBK =
VOUT + ISEC ESR + RDS(ON)
(
)
NSF
RDS(ON) = on-resistance of the synchronous MOSFET MS
ISEC = transformer secondary current
ESR = impedance of secondary circuit capacitor, winding
and traces
NSF = transformer effective secondary-to-flyback winding
turns ratio (i.e., NS/NFLBK)
The flyback voltage is scaled by an external resistive
divider R1/R2 and presented at the FB pin. The feedback
amplifier compares the voltage to the internal bandgap
reference.Thefeedbackampisactuallyatransconductance
amplifier whose output is connected to VCMP only during
a period in the flyback time. An external capacitor on
the VCMP pin integrates the net feedback amp current to
provide the control voltage to set the current mode trip
point. The regulation voltage at the FB pin is nearly equal
to the bandgap reference VFB because of the high gain in
the overall loop. The relationship between VFLBK and VFB
is expressed as:
VFLBK =
R1
+R2
R2
VFB
APPLICATIONS INFORMATION
Combining this with the previous VFLBK expression yields
an expression for VOUT in terms of the internal reference,
programming resistors and secondary resistances:
VOUT =
R1+R2
R2
VFB NSF
ISEC ESR+RDS(ON)
(
)
The effect of nonzero secondary output impedance is
discussed in further detail (see Load Compensation
Theory).Thepracticalaspectsofapplyingthisequationfor
VOUT are found in subsequent sections of the Applications
Information.
Feedback Amplifier Dynamic Theory
So far, this has been a pseudo-DC treatment of flyback
feedback amplifier operation. But the flyback signal is a
pulse, not a DC level. Provision is made to turn on the
flyback amplifier only when the flyback pulse is present,
using the enable signal as shown in the timing diagram
(Figure 10b).
Minimum Output Switch On Time (tON(MIN))
The LTC4278 affects output voltage regulation via flyback
pulse action. If the output switch is not turned on, there
is no flyback pulse and output voltage information is
not available. This causes irregular loop response and
start-up/latchup problems. The solution is to require the
primary switch to be on for an absolute minimum time per
each oscillator cycle. To accomplish this the current limit
feedbackisblankedeachcyclefortON(MIN).Iftheoutputload
is less than that developed under these conditions, forced
continuous operation normally occurs. See subsequent
discussions in the Applications Information section for
further details.
Enable Delay Time (ENDLY)
The flyback pulse appears when the primary-side switch
shutsoff.However,ittakesafinitetimeuntilthetransformer
primary-side voltage waveform represents the output
voltage. This is partly due to rise time on the primary-
side MOSFET drain node, but, more importantly, is due
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8873MML | IC ETHERNET SWITCH 3PORT 64-LQFP |
| V72A3V3C264BG2 | CONVERTER MOD DC/DC 3.3V 264W |
| V72A3V3C264BG | CONVERTER MOD DC/DC 3.3V 264W |
| V72A3V3C264BF3 | CONVERTER MOD DC/DC 3.3V 264W |
| KSZ8851-16MLLI | IC MAC CTLR 1PORT W/BUS 48-TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4278IDKDTRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:IEEE 802.3at PD with Synchronous No-Opto Flyback Controller and 12V Aux Support |
| LTC4280 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4280CUFD | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4280CUFD#PBF | 功能描述:IC CONTROLLER HOT SWAP QFN-24 RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4280CUFD#TRPBF | 功能描述:IC CTLR HOT SWAP I2C MON 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發(fā)布緊急采購，3分鐘左右您將得到回復。