- 您現在的位置：買賣IC網 > Datasheet目錄42 > LTC4214-1IMS#TRPBF (Linear Technology)IC CTRLR HOTSWAP NEGVOLT 10MSOP Datasheet資料下載
參數資料
| 型號： | LTC4214-1IMS#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 12/32頁 |
| 文件大小： | 277K |
| 描述： | IC CTRLR HOTSWAP NEGVOLT 10MSOP |
| 標準包裝： | 2,500 |
| 類型： | 熱交換控制器 |
| 應用： | 通用 |
| 內部開關： | 無 |
| 電源電壓： | 6 V ~ 16 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC4214-1/LTC4214-2
12
421412f
OPERATIO
turn on gradually so that the inrush into the load capaci-
tance remains a low value. The output will simply ramp to
12V and the LTC4214 will fully enhance the MOSFET. A
second possibility is that the load current exceeds the
soft-start current limit threshold of [V
SS
(t)/20 V
OS
]/R
S
.
In this case the LTC4214 will ramp the output by sourcing
soft-start limited current into the load capacitance. If the
soft-start voltage is below 1.2V, the circuit breaker TIMER
is held low. Above 1.2V, TIMER ramps up. It is important
to set the timer delay so that, regardless of which start-up
mode is used, the TIMER ramp is less than one circuit
breaker delay time. If this condition is not met, the
LTC4214-1 may shut down after one circuit breaker delay
time whereas the LTC4214-2 may continue to autoretry.
Board Removal
If the board is withdrawn from the card cage, the UV/OV
divider is the first to lose connection. This shuts off the
MOSFET and commutates the flow of current in the
connector. When the power pins subsequently separate,
there is no arcing.
Current Control
Three levels of protection handle short-circuit and over-
load conditions. Load current is monitored by SENSE and
resistor R
S
. There are three distinct thresholds at SENSE:
50mV for a timed circuit breaker function; 70mV for an
analog current limit loop; and 200mV for a fast, feedforward
comparator which limits peak current in the event of a
catastrophic short-circuit.
If, owing to an output overload, the voltage drop across
R
S
exceeds 50mV, TIMER sources 40礎 into C
T
. C
T
eventually charges to a 3V threshold and the LTC4214
shuts off. If the overload goes away before C
T
reaches 3V
and SENSE measures less than 50mV, C
T
slowly dis-
charges (5礎). In this way the LTC4214s circuit breaker
function responds to low duty cycle overloads and ac-
counts for fast heating and slow cooling characteristics of
the MOSFET.
Higher overloads are handled by an analog current limit
loop. If the drop across R
S
reaches 70mV, the current
limiting loop servos the MOSFET gate and maintains a
constant output current of 70mV/R
S
. In current limit
mode, V
OUT
typically rises and this increases MOSFET
heating. If V
OUT
> V
DRNCL
(4.2V), connecting an external
resistor, R
D
, between V
OUT
and DRAIN allows the fault
timing cycle to be shortened by accelerating the charging
of the TIMER capacitor. The TIMER pull-up current is
increased by 8 " I
DRN
. Note that because SENSE > 50mV,
TIMER charges C
T
during this time and the LTC4214 will
eventually shut down.
Low impedance failures on the load side of the LTC4214
can produce high current slew rates. Under these condi-
tions, overshoot is inevitable. A fast SENSE comparator
with a threshold of 200mV detects overshoot and pulls
GATE low much harder and hence much faster than the
weaker current limit loop. The 70mV/R
S
current limit loop
then takes over and servos the current as previously
described. As before, TIMER runs and shuts down the
LTC4214 when C
T
reaches 3V.
If C
T
reaches 3V, the LTC4214-1 latches off with a 5礎
pull-up current source whereas the LTC4214-2 starts a
shutdown cooling cycle. The LTC4214-1 circuit breaker
latch is reset by either pulling UV momentarily low or drop-
ping the input voltage V
IN
below the internal UVLO thresh-
old of 4.8V or pulling TIMER momentarily low with a switch.
The LTC4214-2 retries after its shutdown cooling cycle.
Although short-circuits are the most obvious fault type,
several operating conditions may invoke overcurrent pro-
tection. Noise spikes from the backplane or load, transient
currents caused by faults on adjacent circuit boards shar-
ing the same power bus or the insertion of non-hot-
swappable products could cause higher than anticipated
input current and temporary detection of an overcurrent
condition. The action of TIMER and C
T
rejects these events
allowing the LTC4214 to ride out temporary overloads and
disturbances that could trip a simple current comparator
and, in some cases, blow a fuse.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4215IUFD#PBF | IC CNTRLR HOT SWAP 24-QFN |
| LTC4216IDE#TRPBF | IC CNTRLR HOT SWAP 12-DFN |
| LTC4221IGN#TRPBF | IC CTRLR HOTSWAP DUAL 16SSOP |
| LTC4222CG#PBF | IC CTRLR DUAL HOT SWAP 36-SSOP |
| LTC4223CDHD-2#PBF | IC CNTRLR HOT SWAP DUAL 16-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4214-2CMS | 功能描述:IC CTRLR HOTSWAP NEGVOLT 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4214-2CMS#PBF | 功能描述:IC CTRLR HOTSWAP NEGVOLT 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4214-2CMS#TR | 功能描述:IC CONTROLLER HOTSWAP NEG 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4214-2CMS#TRPBF | 功能描述:IC CTRLR HOTSWAP NEGVOLT 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LTC4214-2IMS | 功能描述:IC CONTROLLER HOTSWAP NEG 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。