- 您現在的位置：買賣IC網 > PDF目錄67755 > LC5511D POWER FACTOR CONTROLLER, 18 kHz SWITCHING FREQ-MAX, DIP7 PDF資料下載
參數資料
| 型號： | LC5511D |
| 元件分類： | 穩壓器 |
| 英文描述： | POWER FACTOR CONTROLLER, 18 kHz SWITCHING FREQ-MAX, DIP7 |
| 封裝： | DIP-8/7 |
| 文件頁數： | 14/40頁 |
| 文件大?。?/td> | 888K |
| 代理商： | LC5511D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
21
Allegro MicroSystems, Inc.
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
28106.02
Operation Modes at Startup
Figure 24 shows the operation modes during the startup phase
of the LC551xD, and figure 25 shows those for the LC552xD
and LC552xF. Note that OCP pin voltage, which determines the
timing of quasi-resonant operation, is shown in reference to the
S/GND pin.
During two periods below at startup, IC operation is set to PWM,
with fOSC = 14 kHz:
While the COMP pin voltage (for LC551xD) and FB pin volt-
age (for LC552xD and LC552xF), in reference to S/GND, are
0 to 0.9 V (the control voltage lower limit for the COMP pin,
VCOMP(MIN), and FB pin, VFB(MIN)): During this period, on-time
is fixed at the Leading Edge Blanking Time, tBW = 500 ns.
Until the quasi-resonant signal (OCP pin voltage) reaches the
Quasi-Resonant Operation Threshold Voltage-1, VBD(TH1)=
0.24 V: During this period, the output voltage is low; therefore,
the auxiliary winding voltage, VD , is low. Thus the quasi-reso-
nant signal is low.
After those startup operations the output voltage starts increasing,
when the OCP pin voltage reaches VBD(TH1) = 0.24 V, the device
is switched to quasi-resonant operation (figure 26).
Soft-Start Function
The soft-start function reduces power stress on the incorporated
MOSFET and secondary diode during the startup phase.
LC551xD series (non-isolated designs)
The soft-start operation
begins when the COMP pin voltage reaches VCOMP(MIN) = 0.9 V
and lasts until the output current becomes constant. During that
period, the output power gradually increases.
During this period, check the below items:
VCC pin voltage does not drop to the Operation Stop Voltage,
VCC(OFF)
Output current reaches the target value before the overload pro-
tection (OLP) is activated by the COMP pin voltage reaching
VCOMP(OLP)2 = 4.5 V
V
CC Pin
Voltage
COMP Pin
Voltage
Output (LED)
Current, I
OUT
Drain
Current, I
D
S/GND
IC turn on
S/GND
GND(I
OUT)
Duration
PWM
(QR)
VCOMP(MIN)= 0.90 V
VCC(BIAS 1
) = 11.0 V
Soft-Start Period
Target
Current
GND(I
D )
Constant current operation
t
ON= tBW(500 ns)
VCC Pin
Voltage
FB Pin
Voltage
Output (LED)
Current, I
OUT
Drain
Current, I
D
S/GND
IC turn on
S/GND
GND(I
OUT)
Duration
PWM
(QR)
VFB (MIN)= 0.90 V
VCC(BIAS 1
) = 11.0 V
Soft-Start Period
Target
Current
GND(I
D )
Constant current operation
t
ON= tBW(500 ns)
Figure 24. Soft-start operation waveforms at startup (LC551xD)
Figure 25. Soft-start operation waveforms at startup (LC552xD/ LC552xF)
GND(ID)
S/GND
VBD(TH1)
PWM operation Quasi-resonant operation (QR)
OCP Pin
Voltage
Drain
Current, ID
Figure 26. OCP Pin Voltage (with time scale expanded)
相關PDF資料 |
PDF描述 |
|---|---|
| LC5521D | 2.5 A POWER FACTOR CONTROLLER, 18 kHz SWITCHING FREQ-MAX, DIP7 |
| LC72137 | PLL FREQUENCY SYNTHESIZER, 40 MHz, PDIP22 |
| LC72137M | PLL FREQUENCY SYNTHESIZER, 40 MHz, PDSO20 |
| LC72137 | PLL FREQUENCY SYNTHESIZER, 40 MHz, PDIP22 |
| LC72137M | PLL FREQUENCY SYNTHESIZER, 40 MHz, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC5512B-10F256C | 功能描述:CPLD - 復雜可編程邏輯器件 PROGRAM EXPANDED LOG RoHS:否 制造商:Lattice 系列: 存儲類型:EEPROM 大電池數量:128 最大工作頻率:333 MHz 延遲時間:2.7 ns 可編程輸入/輸出端數量:64 工作電源電壓:3.3 V 最大工作溫度:+ 90 C 最小工作溫度:0 C 封裝 / 箱體:TQFP-100 |
| LC5512B-10F256I | 功能描述:CPLD - 復雜可編程邏輯器件 PROGRAM EXPANDED LOG RoHS:否 制造商:Lattice 系列: 存儲類型:EEPROM 大電池數量:128 最大工作頻率:333 MHz 延遲時間:2.7 ns 可編程輸入/輸出端數量:64 工作電源電壓:3.3 V 最大工作溫度:+ 90 C 最小工作溫度:0 C 封裝 / 箱體:TQFP-100 |
| LC5512B-10F484C | 功能描述:CPLD - 復雜可編程邏輯器件 Use ispMACH 4000B RoHS:否 制造商:Lattice 系列: 存儲類型:EEPROM 大電池數量:128 最大工作頻率:333 MHz 延遲時間:2.7 ns 可編程輸入/輸出端數量:64 工作電源電壓:3.3 V 最大工作溫度:+ 90 C 最小工作溫度:0 C 封裝 / 箱體:TQFP-100 |
| LC5512B-10F484I | 功能描述:CPLD - 復雜可編程邏輯器件 Use ispMACH 4000B RoHS:否 制造商:Lattice 系列: 存儲類型:EEPROM 大電池數量:128 最大工作頻率:333 MHz 延遲時間:2.7 ns 可編程輸入/輸出端數量:64 工作電源電壓:3.3 V 最大工作溫度:+ 90 C 最小工作溫度:0 C 封裝 / 箱體:TQFP-100 |
| LC5512B-10Q208C | 功能描述:CPLD - 復雜可編程邏輯器件 Use ispMACH 4000B RoHS:否 制造商:Lattice 系列: 存儲類型:EEPROM 大電池數量:128 最大工作頻率:333 MHz 延遲時間:2.7 ns 可編程輸入/輸出端數量:64 工作電源電壓:3.3 V 最大工作溫度:+ 90 C 最小工作溫度:0 C 封裝 / 箱體:TQFP-100 |
發布緊急采購，3分鐘左右您將得到回復。