352
LBC:
Low Battery Check. If this bit is set, the FLEX decoder will check the status of the LOBAT
port just before leaving this receiver state. (value after reset=0)
CLS:
Control Line Setting. This is the value to be output on the receiver control lines (S0-S7) for
this receiver state. (value after reset=0)
ST:
Step Time. This is the time the FLEX decoder is to keep the receiver off before applying the
first warm up state’s receiver control value to the receiver control lines. The setting is in steps of
625μs. Valid values are 625μs (ST=01) to 159.375ms (ST=FF in hexadecimal). (value after
reset=625μs)
2. Receiver Warm Up Setting Packets
Table 12-12 Receiver Warm Up Setting Packet Bit Assignments
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Byte 3
0
0
0
1
0
s
2
0
s
1
0
s
0
0
Byte 2
SE
0
0
0
LBC
Byte 1
CLS
7
0
CLS
6
ST
6
CLS
5
ST
5
CLS
4
ST
4
CLS
3
ST
3
CLS
2
ST
2
CLS
1
ST
1
CLS
0
ST
0
Byte 0
s:
Setting Number. Receiver control setting for which this packet’s values are to be applied. The
following truth table shows the names of each of the values for s that apply to this packet.
s
2
0
s
1
0
s
0
1
Setting Name
Warm Up 1
0
1
0
Warm Up 2
0
1
1
Warm Up 3
1
0
0
Warm Up 4
1
0
1
Warm Up 5
SE:
Step Enable. The receiver setting is enabled when the bit is set. If a step in the warm up
sequence is disabled, the disabled step and all remaining steps will be skipped. (value after
reset=0)
LBC:
Low Battery Check. If this bit is set, the FLEX decoder will check the status of the LOBAT
port just before leaving this receiver state. (value after reset=0)
CLS:
Control Line Setting. This is the value to be output on the receiver control lines (S0-S7) for
this receiver state. (value after reset=0)