- 您現在的位置：買賣IC網 > PDF目錄1922 > HC5515CMZ (Intersil)IC SLIC ITU CO/PABX LP 28-PLCC PDF資料下載
參數資料
| 型號： | HC5515CMZ |
| 廠商： | Intersil |
| 文件頁數： | 5/20頁 |
| 文件大小： | 0K |
| 描述： | IC SLIC ITU CO/PABX LP 28-PLCC |
| 標準包裝： | 925 |
| 功能： | 用戶線路接口概念（SLIC） |
| 電路數： | 1 |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 功率（瓦特）： | 1.5W |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-LCC（J 形引線） |
| 供應商設備封裝： | 28-PLCC（11.51x11.51） |
| 包裝： | 管件 |
| 包括： | 可編程回路電流檢測器，振鈴?fù)禉z測器，熱關機 |
13
FN4235.6
June 6, 2006
Longitudinal Impedance
The feedback loop described in Figure 19(A, B) realizes the
desired longitudinal impedances from tip to ground and from
ring to ground. Nominal longitudinal impedance is resistive
and in the order of 22
.
In the presence of longitudinal currents this circuit attenuates
the voltages that would otherwise appear at the tip and ring
terminals, to levels well within the common mode range of
the SLIC. In fact, longitudinal currents may exceed the
programmed DC loop current without disturbing the SLIC’s
VF transmission capabilities.
The function of this circuit is to maintain the tip and ring
voltages symmetrically around VBAT/2, in the presence of
longitudinal currents. The differential transconductance
amplifiers GT and GR accomplish this by sourcing or sinking
the required current to maintain VC at VBAT/2.
When a longitudinal current is injected onto the tip and ring
inputs, the voltage at VC moves from it’s equilibrium value
VBAT/2. When VC changes by the amount DVC, this change
appears between the input terminals of the differential
transconductance amplifiers GT and GR. The output of GT
and GR are the differential currents DI1 and DI2, which in
turn feed the differential inputs of current sources IT and IR
respectively. IT and IR have current gains of 250 single
ended and 500 differentially, thus leading to a change in IT
and IR that is equal to 500(DI) and 500(DI2).
The circuit shown in Figure 19(B) illustrates the tip side of
the longitudinal network. The advantages of a differential
input current source are: improved noise since the noise due
to current source 2IO is now correlated, power savings due
to differential current gain and minimized offset error at the
Operational Amplifier inputs via the two 5k
resistors.
Digital Logic Inputs
Table 1 is the logic truth table for the TTL compatible logic
input pins. The HC5515 has an enable input pin (E0) and
two control inputs pins (C1, C2).
The enable pin E0 is used to enable or disable the DET
output pin. The DET pin is enabled if E0 is at a logic level 0
and disabled if E0 is at a logic level 1.
A combination of the control pins C1 and C2 is used to select
1 of the 4 possible operating states. A description of each
operating state and the control logic follow:
Open Circuit State (C1 = 0, C2 = 0)
In this state the SLIC is effectively off. All detectors and
both the tip and ring line drive amplifiers are powered
down, presenting a high impedance to the line. Power
dissipation is at a minimum.
Active State (C1 = 0, C2 = 1)
The tip output is capable of sourcing loop current and for
open circuit conditions is about -4V from ground. The ring
output is capable of sinking loop current and for open circuit
conditions is about VBAT +4V. VF signal transmission is
normal. The loop current detector is active, E0 determines if
the detector is gated to the DET output.
TIP
RING
HC5515
RRT
VBAT
ERG
R3
R4
R2
R1
DR
DT
RING TRIP
COMPARATOR
DET
CRT
RINGRLY
RING
RELAY
+
-
FIGURE 18. RING TRIP CIRCUIT FOR BATTERY BACKED
RINGING
TIP
RING
VBAT/2
GT
GR
I1
I
2
I2
IT
IR
RLARGE
VT
+
-
ILONG
HC5515
ILONG
V
R
+
-
VC
+
-
VBAT/2
VC
RLARGE
TIP
RING
5k
5k
20
+
-
2I0
I1
TIP CURRENT SOURCE
WITH DIFFERENTIAL INPUTS
TIP DIFFERENTIAL
TRANSCONDUCTANCE AMPLIFIER
FIGURE 19A.
FIGURE 19B.
FIGURE 19. LONGITUDINAL IMPEDANCE NETWORK
HC5515
相關PDF資料 |
PDF描述 |
|---|---|
| HC9P5504B-5ZX96 | IC SLIC EIA/ITU PABX 24-SOIC |
| HD3-6402R-9Z | IC UART CMOS 5V 2MHZ 40-DIP |
| HD9P6409-9Z96 | IC MED MANCHESTER 1MHZ 20-SOIC |
| HI1-0390-2 | IC SWITCH DUAL SPDT 16CDIP |
| HI1-0524-5 | IC VIDEO MULTIPLEXER 4X1 18CDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HC5515CP | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HC5515IM | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述: |
| HC5515IMR4717 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HC5515IP | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HC5515IP-5 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。