參數資料
型號: DS21Q44T
元件分類: 通信及網絡
英文描述: Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
中文描述: Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
文件頁數: 41/105頁
文件大小: 620K
代理商: DS21Q44T
DS21Q44
41 of 105
Code violations are defined as consecutive bipolar violations of the same polarity. In most applications,
the framer should be programmed to count BPVs when receiving AMI code and to count CVs when
receiving HDB3 code. This counter increments at all times and is not disabled by loss of sync conditions.
The counter saturates at 65,535 and will not rollover. The bit error rate on a E1 line would have to be
greater than 10** –2 before the VCR would saturate.
VCR1: UPPER BIPOLAR VIOLATION COUNT REGISTER 1
(Address=00 Hex)
VCR2: LOWER BIPOLAR VIOLATION COUNT REGISTER 2
(Address=01 Hex)
(MSB)
V15
V7
(LSB)
V8
V0
V14
V6
V13
V5
V12
V4
V11
V3
V10
V2
V9
V1
VCR1
VCR2
SYMBOL
V15
V0
POSITION
VCR1.7
VCR2.0
NAME AND DESCRIPTION
MSB of the 16–bit code violation count
LSB of the 10–bit code violation count
CRC4 Error Counter
CRC4 Count Register 1 (CRCCR1) is the most significant word and CRCCR2 is the least significant
word of a 10–bit counter that records word errors in the Cyclic Redundancy Check 4 (CRC4). Since the
maximum CRC4 count in a one second period is 1000, this counter cannot saturate. The counter is
disabled during loss of sync at either the FAS or CRC4 level; it will continue to count if loss of
multiframe sync occurs at the CAS level.
CRCCR1: CRC4 COUNT REGISTER 1
(Address=02 Hex)
CRCCR2: CRC4 COUNT REGISTER 2
(Address=03 Hex)
(MSB)
(note 1)
CRC7
(LSB)
CRC8
CRC0
(note 1)
CRC6
(note 1)
CRC5
(note 1)
CRC4
(note 1)
CRC3
(note 1)
CRC2
CRC9
CRC1
CRCCR1
CRCCR2
SYMBOL
POSITION
NAME AND DESCRIPTION
CRC9
CRC0
CRCCR1.1
CRCCR2.0
MSB of the 10–Bit CRC4 error count
LSB of the 10–Bit CRC4 error count
Note:
1.
The upper six bits of CRCCR1 at address 02 are the most significant bits of the 12–bit FAS error
counter.
E–Bit Counter
E–bit Count Register 1 (EBCR1) is the most significant word and EBCR2 is the least significant word of
a 10–bit counter that records Far End Block Errors (FEBE) as reported in the first bit of frames 13 and 15
on E1 lines running with CRC4 multiframe. These count registers will increment once each time the
received E–bit is set to zero. Since the maximum E–bit count in a one second period is 1000, this counter
cannot saturate. The counter is disabled during loss of sync at either the FAS or CRC4 level; it will
continue to count if loss of multiframe sync occurs at the CAS level.
相關PDF資料
PDF描述
DS21Q44TN MICROSWITCH, SPDT, SIM ROLLER LEVER; Current, contact AC:5A; Force, operating:91.75gf; Travel, pre:16.0mm; Centres, fixing LxW:22.2mm; Temp, op. max:120(degree C); Temp, op. min:-40(degree C); Length / Height, external:9.25mm; Width, RoHS Compliant: Yes
DS2251T-128-16 CONNECTOR ACCESSORY
DS2251T-32-16 128k Soft Microcontroller Module
DS2251T-64-16 CONNECTOR ACCESSORY
DS2251 128k Soft Microcontroller Module
相關代理商/技術參數
參數描述
DS21Q44T+ 功能描述:網絡控制器與處理器 IC Enhanced Quad E1 Framer RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21Q44TN 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21Q48 功能描述:網絡控制器與處理器 IC 5V Quad E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21Q48A3N 功能描述:網絡控制器與處理器 IC 5V Quad E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21Q48B 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray