- 您現在的位置：買賣IC網 > PDF目錄376802 > DM9000E (Electronic Theatre Controls, Inc.) ISA TO ETHERNET MAC CONTROLLER WITH INTEGRATED 10/100 PHY PDF資料下載
參數資料
| 型號： | DM9000E |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | ISA TO ETHERNET MAC CONTROLLER WITH INTEGRATED 10/100 PHY |
| 中文描述： | ISA以以太網MAC控制器，它集成10/100網卡芯片 |
| 文件頁數： | 32/54頁 |
| 文件大?。?/td> | 575K |
| 代理商： | DM9000E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
DM9000
ISA to Ethernet MAC Controller with Integrated 10/100 PHY
32
Final
Version: DM9000-DS-F02
June 26, 2002
9.5 100Base-TX Operation
The block diagram in figure 3 provides an overview of
the functional blocks contained in the transmit section.
The transmitter section contains the following
functional blocks:
- 4B5B Encoder
- Scrambler
- Parallel to Serial Converter
- NRZ to NRZI Converter
- NRZI to MLT-3
- MLT-3 Driver
9.5.1 4B5B Encoder
The 4B5B encoder converts 4-bit (4B) nibble data
generated by the MAC Reconciliation Layer into a 5-
bit (5B) code group for transmission, see reference
Table 1. This conversion is required for control and
packet data to be combined in code groups. The
4B5B encoder substitutes the first 8 bits of the MAC
preamble with a J/K code-group pair (11000 10001)
upon transmit. The 4B5B encoder continues to
replace subsequent 4B preamble and data nibbles
with corresponding 5B code-groups. At the end of the
transmit packet, upon the deassertion of the Transmit
Enable signal from the MAC Reconciliation layer, the
4B5B encoder injects the T/R code-group pair (01101
00111) indicating the end of frame. After the T/R
code-group pair, the 4B5B encoder continuously
injects IDLEs into the transmit data stream until
Transmit Enable is asserted and the next transmit
packet is detected.
The DM9000 includes a Bypass 4B5B conversion
option within the 100Base-TX Transmitter for support
of applications like 100 Mbps repeaters which do not
require 4B5B conversion.
9.5.2 Scrambler
The scrambler is required to control the radiated
emissions (EMI) by spreading the transmit energy
across the frequency spectrum at the media
connector and on the twisted pair cable in 100Base-
TX operation.
By scrambling the data, the total energy presented to
the cable is randomly distributed over a wide
frequency range. Without the scrambler, energy levels
on the cable could peak beyond FCC limitations at
frequencies related to the repeated 5B sequences,
like the continuous transmission of IDLE symbols. The
scrambler output is combined with the NRZ 5B data
from the code-group encoder via an XOR logic
function. The result is a scrambled data stream with
sufficient
randomization
emissions at critical frequencies.
to
decrease
radiated
9.5.3 Parallel to Serial Converter
The Parallel to Serial Converter receives parallel 5B
scrambled data from the scrambler, and serializes it
(converts it from a parallel to a serial data stream).
The serialized data stream is then presented to the
NRZ to NRZI encoder block
9.5.4 NRZ to NRZI Encoder
After the transmit data stream has been scrambled
and serialized, the data must be NRZI encoded for
compatibility with the TP-PMD standard, for 100Base
-TX transmission over Category-5 unshielded twisted
pair cable.
9.5.5 MLT-3 Converter
The MLT-3 conversion is accomplished by converting
the data stream output, from the NRZI encoder into
two binary data streams, with alternately phased logic
one event.
9.5.6 MLT-3 Driver
The two binary data streams created at the MLT-3
converter are fed to the twisted pair output driver,
which converts these streams to current sources and
alternately drives either side of the transmit
transformer
’
s primary winding, resulting in a minimal
current MLT-3 signal. Refer to figure 4 for the block
diagram of the MLT-3 converter.
相關PDF資料 |
PDF描述 |
|---|---|
| DM9006CJ | Gate Expander |
| DM9006CN | Gate Expander |
| DM9009CJ | Dual 4-input NAND Gate |
| DM9009CN | Dual 4-input NAND Gate |
| DM9002CN | Quad 2-input NAND Gate |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DM9000E-H | 功能描述:以太網開發工具 ETHERNET CONTROLLER HEADER BRD 50x40mm RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| DM9000EP | 制造商:DAVICOM 功能描述:IC ENET CNTRL 10/100M PHY 100LQFP 制造商:DAVICOM 功能描述:IC, ENET CNTRL, 10/100M PHY, 100LQFP 制造商:DAVICOM 功能描述:IC, ENET CNTRL, 10/100M PHY, 100LQFP; Data Rate:100Mbps; Ethernet Type:IEEE 802.3u; Supply Voltage Min:3.135V; Supply Voltage Max:3.465V; Digital IC Case Style:LQFP; No. of Pins:100; Interface Type:MII; Operating Temperature Min:0C;;RoHS Compliant: Yes |
| DM9000電路圖-1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:型號DM9000電路圖1 |
| DM9000電路圖-2 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DM9000電路圖-2 |
| DM9002CJ/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Quad 2-input NAND Gate |
發布緊急采購，3分鐘左右您將得到回復。