參數資料
型號: DAC1005D750HW
廠商: NXP Semiconductors N.V.
元件分類: 外設及接口
英文描述: Dual 10-bit DAC, up to 750 Msps; 2x 4x and 8x interpolating
封裝: DAC1005D750HW/C1<SOT638-1 (HTQFP100)|<<http://www.nxp.com/packages/SOT638-1.html<1<Always Pb-free,;DAC1005D750HW/C1<SOT638-1 (HTQFP100)|<<http://www.nxp.com/packages/SOT6
文件頁數: 13/42頁
文件大小: 353K
代理商: DAC1005D750HW
DAC1005D750
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 3 — 7 June 2011
13 of 42
NXP Semiconductors
DAC1005D750
Dual 10-bit DAC, up to 750 Msps; 4x and 8x interpolating
10. Application information
10.1 General description
The DAC1005D750 is a dual 10-bit DAC which operates at up to 750 Msps. Each DAC
consists of a segmented architecture, comprising a 6-bit thermometer sub-DAC and an
4-bit binary weighted sub-DAC.
The input data rate of up to 185 MHz combined with the maximum output sampling rate of
750 Msps make the DAC1005D750 extremely flexible in wide bandwidth and multi-carrier
systems. The device’s quadrature modulator and 32-bit NCO simplifies system frequency
selection. This is also possible because the 4
and 8
interpolation filters remove
undesired images.
A SYNC signal is provided to synchronize data when the PLL is in the off state.
Two modes are available for the digital input. In Dual-port mode, each DAC uses its own
data input line. In Interleaved mode, both DACs use the same data input line.
The on-chip PLL enables generation of the internal clock signals for the digital circuitry
and the DAC from a low speed clock. The PLL can be bypassed enabling the use of an
external, high-speed clock.
Each DAC generates two complementary current outputs on pins IOUTAP/IOUTAN and
IOUTBP/IOUTBN. This provides a full-scale output current (I
O(fs)
) up to 22 mA. An internal
reference is available for the reference current which is externally adjustable using pin
VIRES.
There are also some embedded features to provide an analog offset correction (auxiliary
DACs) and digital offset control as well as for gain adjustment. All the functions can be set
using the SPI.
The DAC1005D750 operates at both 3.3 V and 1.8 V each of which has separate digital
and analog power supplies. The digital input is 1.8 V and 3.3 V compliant and the clock
input is LVDS compliant.
10.2 Serial peripheral interface
10.2.1
Protocol description
The DAC1005D750 Serial Peripheral Interface (SPI) is a synchronous serial
communication port allowing easy interfacing with many industry microprocessors. It
provides access to the registers that define the operating modes of the chip in both write
and read modes.
This interface can be configured as a 3-wire type (SDIO as a bidirectional pin) or a 4-wire
type (SDIO and SDO as unidirectional pins, input and output port respectively). In both
configurations, SCLK acts as the serial clock and SCS_N acts as the serial chip select
bar.
Each read/write operation is sequenced by the SCS_N signal and enabled by a LOW
assertion to drive the chip with 1 to 4 bytes, depending on the content of the instruction
byte (see
Table 7
).
相關PDF資料
PDF描述
DAC1201D125HL Dual 12-bit DAC, up to 125 Msps
DAC1201D125HL Dual 12-bit DAC, up to 125 Msps
DAC1203D160HW Dual 12 bits DAC, up to 160 MHz, 2 x interpolation
DAC1203D160HW Dual 12 bits DAC, up to 160 MHz, 2 x interpolation
DAC1205D650HW Dual 12-bit DAC, up to 650 Msps; 2x 4x and 8x interpolating
相關代理商/技術參數
參數描述
DAC1005D750HW/C1,5 功能描述:數模轉換器- DAC DUAL 10BITS DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
DAC1006 制造商:NSC 制造商全稱:National Semiconductor 功能描述:DOUBLE-BUFFERED D TO A CONVERTERS
DAC1006 WAF 制造商:Texas Instruments 功能描述:
DAC1006LCJ 制造商:NSC 制造商全稱:National Semiconductor 功能描述:DOUBLE-BUFFERED D TO A CONVERTERS