- 您現在的位置：買賣IC網 > PDF目錄16461 > CDB4955A (Cirrus Logic Inc)EVALUATION BOARD FOR CS4955A PDF資料下載
參數資料
| 型號： | CDB4955A |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 28/60頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVALUATION BOARD FOR CS4955A |
| 標準包裝： | 1 |
| 主要目的： | 視頻，視頻處理 |
| 嵌入式： | 是，其它 |
| 已用 IC / 零件： | CS4955 |
| 主要屬性： | NTSC/PAL 數字視頻編碼器 |
| 次要屬性： | 圖形用戶界面，RS-232 接口 |
| 已供物品： | 板 |
| 相關產品： | CS4954-CQZR-ND - IC VID ENCODER NTSC/PAL 48-TQFP 598-1682-ND - IC VIDEO ENCODER NTSC/PAL 48TQFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
CS4954 CS4955
34
DS278F6
current flow from the output. To completely dis-
able or for low power device operation, the blue
DAC can be totally shut down via the B_PD con-
trol register bit in Control Register 4 (0×04). In this
mode turn-on using the control register will not be
instantaneous.
7.4.7 DAC Useage Rules
If some of the 6 DACs are not used, it is strongly
recommended to power them down (see
CONTROL_4 register) in order to reduce the pow-
er dissipation.
Depending on the external resistor connected to the
ISET pin the output drive of the DACs can be
changed. An external resistor of 4 k
Ω must be con-
nected to the ISET pin for normal operation.
There are two outpout impedance modes that the
DACs can be operated in. The first mode is the high
impedance mode (LOW_IMP bit set to 0). In this
mode, the DAC output drives a double terminated
300
Ω load and will output a video signal which
conforms to the proper analog video specifications.
External buffers will be needed if the DAC output
load differs from a double terminated 300
Ω load.
The second mode is the low impedence mode
(LOW_IMP but set to 1). In this mode, the DAC
output drives a double terminated 75
Ω load and
will output a video signal which conforms to the
proper analog video specifications. No external
buffers are necessary. The ouputs can directly drive
a television input.
Note that for power dissipation purposes it is not
always possible to have all the 6 DACs active at the
same time. Table 8 shows the maximum number of
active DACs allowed depending on the power sup-
ply and low/high impedance modes. If less than 6
DACs are allowed to be active, the other DACs
must be powered down (see CONTROL_4 regis-
ter).
8.
PROGRAMMING
8.1
Host Control Interface
The CS4954/5 host control interface can be config-
ured for IC or 8-bit parallel operation. The
CS4954/5 will default to IC operation when the
RD and WR pins are both tied low at power up. The
RD and WR pins are active for 8-bit parallel oper-
ation only.
8.1.1 IC Interface
The CS4954/5 provides an IC interface for access-
ing the internal control and status registers. Exter-
nal pins are a bidirectional data pin (SDA) and a
serial input clock (SCL). The protocol follows the
IC specifications. A complete data transfer is
shown in Figure 26. Note that this IC interface
will work in Slave Mode only - it is not a bus mas-
ter.
SDA and SCL are connected via an external pull-
up resistor to a positive supply voltage. When the
bus is free, both lines are high. The output stages of
devices connected to the bus must have an open-
drain or open-collector in order to perform the
wired-AND function. Data on the IC bus can be
transferred at a rate of up to 400 Kbits/sec in fast
mode. The number of interfaces to the bus is solely
dependent on the limiting bus capacitance of 400
pF. When 8-bit parallel interface operation is being
used, SDA and SCL can be tied directly to ground.
The IC bus address for the CS4954/5 is program-
mable via the I2C_ADR Register (0×0F). When
IC interface operation is being used, RD and WR
Nominal Power
supply
Low/High
Impedance
mode
maximum # of
active DACs
3.3V
Low Impedance
3
3.3V
High Impedance
6
5.0V
Low Impedance
3
5.0V
High Impedance
6
Table 8. Maximum DAC Numbers
相關PDF資料 |
PDF描述 |
|---|---|
| VE-241-EX | CONVERTER MOD DC/DC 12V 75W |
| EB43-S0C2040X | CONN EDGEBOARD DUAL 40POS 3A |
| M3TTK-1436R | IDC CABLE - MSD14K/MC14M/MSD14K |
| GSM10DRTI-S13 | CONN EDGECARD 20POS .156 EXTEND |
| M3DYK-1006J | IDC CABLE - MKR10K/MC10G/MPD10K |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDB-496122-EV2 | 制造商:Cirrus Logic 功能描述: |
| CDB496122-EV2 | 功能描述:音頻 IC 開發工具 Eval Bd CobraNet Trnspt/AdNtwrk Prcsr RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB49X | 制造商:Cirrus Logic 功能描述:EVAL BD - BASE BOARD FOR AUDIO DSP - Boxed Product (Development Kits) |
| CDB-5 | 功能描述:電線導管 5’ Brown RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
| CDB5012 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Evaluation Board |
發布緊急采購，3分鐘左右您將得到回復。