- 您現在的位置：買賣IC網 > PDF目錄298893 > BXM80526B600128 (INTEL CORP) 64-BIT, 600 MHz, MICROPROCESSOR, PBGA495 PDF資料下載
參數資料
| 型號： | BXM80526B600128 |
| 廠商： | INTEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 64-BIT, 600 MHz, MICROPROCESSOR, PBGA495 |
| 封裝： | BGA2-495 |
| 文件頁數： | 63/74頁 |
| 文件大?。?/td> | 870K |
| 代理商： | BXM80526B600128 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁當前第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Mobile Intel Celeron Processor (0.18) in BGA2 and Micro-PGA2 Packages
at 700MHz, 650 MHz, 600 MHz, 550 MHz, 500 MHz, 450 MHz,
Low-voltage 500 MHz, and Low-voltage 400A MHz
Datasheet
Order#-XXX
59
RP# (I/O - GTL+)
The RP# (Request Parity) signal is driven by the request initiator and provides parity protection on
ADS# and REQ[4:0]#. RP# should be connected to the appropriate pins/balls on both agents on
the system bus.
A correct parity signal is high if an even number of covered signals are low and low if an odd
number of covered signals are low. This definition allows parity to be high when all covered
signals are high.
RS[2:0]# (I - GTL+)
The RS[2:0]# (Response Status) signals are driven by the response agent (the agent responsible for
completion of the current transaction) and must be connected to the appropriate pins/balls on both
agents on the system bus.
RSP# (I - GTL+)
The RSP# (Response Parity) signal is driven by the response agent (the agent responsible for
completion of the current transaction) during assertion of RS[2:0]#. RSP# provides parity
protection for RS[2:0]#. RSP# should be connected to the appropriate pins/balls on both agents on
the system bus.
A correct parity signal is high if an even number of covered signals are low, and it is low if an odd
number of covered signals are low. During Idle state of RS[2:0]# (RS[2:0]#=000), RSP# is also
high since it is not driven by any agent guaranteeing correct parity.
RSVD (TBD)
The RSVD (Reserved) signal is currently unimplemented but is reserved for future use. Leave this
signal unconnected. Intel recommends that a routing channel for this signal be allocated.
RTTIMPEDP (Analog)
The RTTIMPEDP (RTT Impedance/PMOS) signal is used to configure the on-die GTL+
termination. Connect the RTTIMPEDP signal to VSS with a 56.2-, 1% resistor.
SLP# (I - 1.5V Tolerant)
The SLP# (Sleep) signal, when asserted in the Stop Grant state, causes the processor to enter the
Sleep state. During the Sleep state, the processor stops providing internal clock signals to all units,
leaving only the Phase-Locked Loop (PLL) still running. The processor will not recognize snoop
and interrupts in the Sleep state. The processor will only recognize changes in the SLP#,
STPCLK# and RESET# signals while in the Sleep state. If SLP# is deasserted, the processor exits
Sleep state and returns to the Stop Grant state in which it restarts its internal clock to the bus and
APIC processor units.
相關PDF資料 |
PDF描述 |
|---|---|
| BXM80526B700128 | 64-BIT, 700 MHz, MICROPROCESSOR, CPGA495 |
| BXM80526B700 | 64-BIT, 700 MHz, MICROPROCESSOR, CPGA495 |
| BXM80536GC2100F | 32-BIT, 2100 MHz, MICROPROCESSOR, CPGA478 |
| BXM80536GC1800F | 32-BIT, 1800 MHz, MICROPROCESSOR, CPGA478 |
| BXM80536GC1600F | 32-BIT, 1600 MHz, MICROPROCESSOR, CPGA478 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BXM80536NC1400ES L7LS | 制造商:Intel 功能描述:CELERON M,360,1.40GHZ,1M CACHE, 400MHZ FSB,1.26V,UFCPGA - Boxed Product (Development Kits) |
| BXMP1000 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1001 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1002 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1003 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。