參數資料
型號: AT43USB353M-AC
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: Low Cost Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
中文描述: 8-BIT, MROM, 24 MHz, RISC MICROCONTROLLER, PQFP48
封裝: 7 X 7 MM, 1.40 MM HEIGHT, 0.50 MM PITCH, PLASTIC, MS-026BBC, LQFP-48
文件頁數: 60/95頁
文件大小: 568K
代理商: AT43USB353M-AC
60
AT43USB353M
3307B–USB–4/04
No-data Status
Response State
The Function Interface Unit receives an IN token from the Host. The FIU responds with a zero
length DATA1 packet until receiving an ACK from the host, then asserts a TX_COMPLETE
interrupt.
Control Read Data
Response State
The Function Interface Unit receives an IN token from the Host. The FIU responds with NAKs
until TX_PACKET_READY is set. The FIU then sends the data in the FIFO upstream, retrying
until it successfully receives an ACK from the host. Finally, the FIU clears the
TX_PACKET_READY bit and asserts a TX_COMPLETE interrupt.
Hardware
Firmware
1.
IN token from Host
2.
Send DATA1(0)
3.
ACK from Host
Set TX COMPLETE
INT
4.
5.
Read UISR
6.
Read CSR0
7.
If SET ADDRESS, program the new
Address, set ADD_EN bit
Clear TX_COMPLETE, clear Data
End, set Force STALL in CAR0
Set UIAR[EP0 INTACK]
8.
9.
Hardware
Firmware
1.
IN token from Host
2.
a. If TX Packet Ready = 1, send
DATA0/DATA1
b. If TX Packet Ready = 0, send NAK
ACK from Host
3.
4.
Clear TX Packet Ready
Set TX Complete
INT
5.
Read UISR
6.
Read CSR0
7.
Clear TX COMPLETE in CAR0:
a. If more data: fill FIFO, set TX
Packet Ready, set DIR in CAR0
b. If no more data: set Force STALL,
set DATA END in CAR0
Set UIAR[EP0 INTACK] to clear
interrupt source
8.
Repeat steps 1 through 8
相關PDF資料
PDF描述
AT43USB355E-AC Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355E-AU Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355M-AC Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355M-AU Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB380 On-The-Go Upgrade of the AT43USB370 USB 2.0 Full-Speed Host/Function Processor
相關代理商/技術參數
參數描述
AT43USB355 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Missed Watchdog Timer Reset
AT43USB355_02 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Full speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355_06 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355E-AC 功能描述:8位微控制器 -MCU USB GAME CONTROL w/EMBED HUB-COM TEMP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT43USB355E-AU 功能描述:8位微控制器 -MCU USB GAME CONTROL w/ EMBED HUB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT