參數資料
型號: ADS1194CZXGT
廠商: TEXAS INSTRUMENTS INC
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PBGA64
封裝: 8 X 8 MM, GREEN, PLASTIC, NFBGA-64
文件頁數: 32/76頁
文件大?。?/td> 1193K
代理商: ADS1194CZXGT
Hi-Z
START
DRDY
CS
SCLK
DIN
DOUT
RDATAOpcode
Status Register+8-ChannelData(152 Bits)
RDATAOpcode
SBAS471B
– APRIL 2010 – REVISED APRIL 2011
RDATA: Read Data
Issue this command after DRDY goes low to read the conversion result (in Stop Read Data Continuous mode).
There is no restriction on the SCLK rate for this command, and there is no wait time needed for the subsequent
commands or data retrieval SCLKs. To retrieve data from the device after RDATA command is issued, make
sure either the START pin is high or the START command is issued. When reading data with the RDATA
command, the read operation can overlap the occurrence of the next DRDY without data corruption. Figure 39
shows the recommended ways to use the RDATA command. RDATA is best suited for ECG and EEG type
systems, where register setting must be read or changed often between conversion cycles.
Figure 39. RDATA Usage
Sending Multi-Byte Commands
The ADS1194/6/8 serial interface decodes commands in bytes and requires four CLK cycles to decode and
execute. Therefore, when sending multi-byte commands, a period of four CLKs must separate the end of one
byte (or opcode) and the next.
Assume CLK is 2.048MHz, then tSDECODE (4 tCLK) is 1.96s. When SCLK is 16MHz, one byte can be transferred
in 500ns. This byte transfer time does not meet the tSDECODE specification; therefore, a delay must be inserted so
the end of the second byte arrives 1.46
s later. If SCLK is 4MHz, one byte is transferred in 2s. Because this
transfer time exceeds the tSDECODE specification, the processor can send subsequent bytes without delay. In this
later scenario, the serial port can be programmed to cease single-byte transfer per cycle to multiple bytes.
38
Copyright
2010–2011, Texas Instruments Incorporated
Product Folder Link(s): ADS1194 ADS1196 ADS1198
相關PDF資料
PDF描述
ADS1251 "ResolutionPlus 24-Bit
ADS5102IPFBR 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
ADS5103 "10 Bit
ADS5103CPFB 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
ADS5103CPFBR 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
相關代理商/技術參數
參數描述
ADS1194IPAG 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power 8-Channel 16-Bit Analog Front-End for Biopotential Measurements
ADS1194IPAGR 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power 8-Channel 16-Bit Analog Front-End for Biopotential Measurements
ADS1196 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power, 8-Channel, 24-Bit Analog Front-End for Biopotential Measurements
ADS1196CPAG 功能描述:模數轉換器 - ADC Low-Pwr6Ch16B Ana Front-End for ECG RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS1196CPAG 制造商:Texas Instruments 功能描述:; Resolution (Bits):16bit; Sampling Rate 制造商:Texas Instruments 功能描述:IC, ADC, 6CH, 16BIT, 8KSPS, TQFP-64