參數資料
型號： AD73311LARSZ-REEL7
廠商： Analog Devices Inc
文件頁數： 21/36頁
文件大?。?/td> 0K
描述： IC PROCESSOR FRONT END LP 20SSOP
標準包裝： 1
位數： 16
通道數： 2
功率（瓦特）： 50mW
電壓 - 電源，模擬： 3V
電壓 - 電源，數字： 3V
封裝/外殼： 20-SSOP（0.209"，5.30mm 寬）
供應商設備封裝： 20-SSOP
包裝： 標準包裝
其它名稱： AD73311LARSZ-REEL7DKR
AD73311
–28–
REV. B
APPENDIX A
Programming a Single AD73311 for Data Mode Operation
This section describes a typical sequence in programming a
single codec to operate in normal DATA mode. It details the
control (program) words that are sent to the device to configure
its internal registers and shows the typical output data received
during both program and data modes. The device is connected
in Frame Sync Loop-Back Mode (see Figure 13), which forces
an input word from the DSP’s Tx Reg each time the codec
outputs a word via the SDO/SDOFS lines. In Step 1, the part
has just been reset and on the first output event the codec pre-
sents an invalid output word
1. The DSP’s Tx Reg contains a
DSP TX REG
CONTROL WORD 1
1 0 000 001 00000011
ADC WORD 1 *
0000 0000 0000 0000
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 1
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 010 00000001
CONTROL WORD 1
1 0 000 001 00000011
ADC WORD 1 *
0000 0000 0000 0000
DSP RX REG
STEP 2
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 010 00000001
ADC WORD 1 *
1011 1001 0000 0011
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 3
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 000 00000001
CONTROL WORD 1
1 0 000 010 00000001
ADC WORD 1 *
1011 1001 0000 0011
DSP RX REG
STEP 4
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 000 00000001
ADC WORD 1 *
1011 1010 0000 0001
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 5
DSP TX REG
DEVICE 1
DAC WORD 1
0111 1111 1111 1111
CONTROL WORD 1
1 0 000 000 00000001
ADC WORD 1 *
1011 1010 0000 0001
DSP RX REG
STEP 6
DSP TX REG
DAC WORD 1
0111 1111 1111 1111
ADC WORD 1
1000 0000 0000 0000
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 7
DSP TX REG
DEVICE 1
DAC WORD 1
0111 1111 1111 1111
DAC WORD 1
0111 1111 1111 1111
ADC WORD 1
1000 0000 0000 0000
DSP RX REG
STEP 8
*ADC SAMPLES DURING PROGRAM MODE ARE INVALID.
DEVICE 1
Figure 33. Programming a Single AD73311 for Normal
control word that programs CRB with the data word 0x03. In
Step 2, the control word from the DSP’s Tx Reg has been sent
to the codec’s SPORT and the output word has been received
by the DSP’s Rx Reg. In Steps 3 and 4, register CRC is pro-
grammed with 0x01, which powers up the analog section. In
Steps 5 and 6, the codec is put into programming mode by
setting the
PGM/DATA bit of CRA. In Step 7, the output word
from the device is now a valid ADC word as the device has been
programmed into data mode. Note also that the codec now
expects DAC data to be sent to it and will interpret any data
from the DSP to be 16-bit DAC data.
NOTE
1Data output by the codec in program mode is invalid and should not be inter-
preted as ADC data. The only exception to this is output caused by register
reads or CEE being enabled on control word writes.
相關PDF資料
PDF描述
MAX9031AXK+T IC COMPARATOR SGL SC70-5
VE-J5D-MW-F4 CONVERTER MOD DC/DC 85V 100W
VI-B6P-IV-S CONVERTER MOD DC/DC 13.8V 150W
VE-J5D-MW-F3 CONVERTER MOD DC/DC 85V 100W
AD73311LARSZ IC PROCESSOR FRONT END LP 20SSOP
相關代理商/技術參數
參數描述
AD73311LARU 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin TSSOP
AD73311LARU-REEL 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin TSSOP T/R
AD73311LARU-REEL7 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin TSSOP T/R
AD73311LARUZ 功能描述:IC PROCESSOR FRONT END LP 20SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模擬前端 (AFE) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:- 通道數:2 功率（瓦特）:- 電壓 - 電源，模擬:3 V ~ 3.6 V 電壓 - 電源，數字:3 V ~ 3.6 V 封裝/外殼:32-VFQFN 裸露焊盤 供應商設備封裝:32-QFN（5x5） 包裝:帶卷 (TR)
AD73311LARUZ-RL 功能描述:IC PROCESSOR FRONT END LP 20SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模擬前端 (AFE) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:- 通道數:2 功率（瓦特）:- 電壓 - 電源，模擬:3 V ~ 3.6 V 電壓 - 電源，數字:3 V ~ 3.6 V 封裝/外殼:32-VFQFN 裸露焊盤 供應商設備封裝:32-QFN（5x5） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*