- 您現在的位置：買賣IC網 > PDF目錄364542 > 87LPC762 (NXP Semiconductors N.V.) Low power, low price, low pin count 20 pin microcontroller with 2 kbyte OTP PDF資料下載
參數資料
| 型號： | 87LPC762 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Low power, low price, low pin count 20 pin microcontroller with 2 kbyte OTP |
| 中文描述： | 低功耗，低價格，低管腳數的2字節OTP 20引腳微控制器 |
| 文件頁數： | 46/57頁 |
| 文件大?。?/td> | 312K |
| 代理商： | 87LPC762 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
Philips Semiconductors
Preliminary data
87LPC762
Low power, low price, low pin count (20 pin)
microcontroller with 2 kbyte OTP
2001 Oct 26
43
Additional Features
The AUXR1 register contains several special purpose control bits that
relate to several chip features. AUXR1 is described in Figure 35.
Software Reset
The SRST bit in AUXR1 allows software the opportunity to reset the
processor completely, as if an external reset or watchdog reset had
occurred. If a value is written to AUXR1 that contains a 1 at bit
position 3, all SFRs will be initialized and execution will resume at
program address 0000. Care should be taken when writing to
AUXR1 to avoid accidental software resets.
Dual Data Pointers
The dual Data Pointer (DPTR) adds to the ways in which the
processor can specify the address used with certain instructions.
The DPS bit in the AUXR1 register selects one of the two Data
Pointers. The DPTR that is not currently selected is not accessible
to software unless the DPS bit is toggled.
Specific instructions affected by the Data Pointer selection are:
INC
DPTR
Increments the Data Pointer by 1.
JMP
@A+DPTR
Jump indirect relative to DPTR value.
MOV
DPTR, #data16
Load the Data Pointer with a 16-bit
constant.
MOVC A, @A+DPTR
Move code byte relative to DPTR to the
accumulator.
MOVX A, @DPTR
Move data byte the accumulator to data
memory relative to DPTR.
MOVX @DPTR, A
Move data byte from data memory
relative to DPTR to the accumulator.
Also, any instruction that reads or manipulates the DPH and DPL
registers (the upper and lower bytes of the current DPTR) will be
affected by the setting of DPS. The MOVX instructions have limited
application for the 87LPC762 since the part does not have an
external data bus. However, they may be used to access EPROM
configuration information (see EPROM Characteristics section).
Bit 2 of AUXR1 is permanently wired as a logic 0. This is so that the
DPS bit may be toggled (thereby switching Data Pointers) simply by
incrementing the AUXR1 register, without the possibility of
inadvertently altering other bits in the register.
SU01223
BIT
AUXR1.7
SYMBOL
KBF
FUNCTION
Keyboard Interrupt Flag. Set when any pin of port 0 that is enabled for the Keyboard Interrupt
function goes low. Must be cleared by software.
Brown Out Disable. When set, turns off brownout detection and saves power. See Power
Monitoring Functions section for details.
Brown Out Interrupt. When set, prevents brownout detection from causing a chip reset and allows
the brownout detect function to be used as an interrupt. See the Power Monitoring Functions
section for details.
Low Power EPROM control bit. Allows power savings in low voltage systems. Set by software. Can
only be cleared by power-on or brownout reset. See the Power Reduction Modes section for details.
Software Reset. When set by software, resets the 87LPC762 as if a hardware reset occurred.
This bit contains a hard-wired 0. Allows toggling of the DPS bit by incrementing AUXR1, without
interfering with other bits in the register.
Reserved for future use. Should not be set to 1 by user programs.
Data Pointer Select. Chooses one of two Data Pointers for use by the program. See text for details.
AUXR1.6
BOD
AUXR1.5
BOI
AUXR1.4
LPEP
AUXR1.3
AUXR1.2
SRST
—
AUXR1.1
AUXR1.0
—
DPS
DPS
—
0
SRST
LPEP
BOI
BOD
KBF
0
1
2
3
4
5
6
7
AUXR1
Reset Value: 00h
Not Bit Addressable
Address: A2h
Figure 35. AUXR1 Register
相關PDF資料 |
PDF描述 |
|---|---|
| 87LPC764 | Low power, low price, low pin count 20 pin microcontroller with 4 kbyte OTP |
| 87LPC767 | Low power, low price, low pin count(20 pin) microcontroller with 4 kB OTP and 8-bit A/D(帶4 kB OTP和8位A/D的低功耗，低價格，少引腳（20引腳）的微控制器) |
| 87LPC768 | Low power, low price, low pin count(20 pin) microcontroller with 4 kB OTP and 8-bit A/D,and Pulse Width Modulator(帶4 kB OTP、8位A/D和脈寬調節的低功耗，低價格，少引腳（20引腳）的微控制器) |
| 87LPC769 | Low power, low price, low pin count(20 pin) microcontroller with 4 kB OTP and 8-bit A/D,and DAC(帶4 kB OTP、8位A/D和D/A轉換的低功耗，低價格，少引腳（20引腳）的微控制器) |
| 87N-1000A-0C | Signal Conditioner |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 87LPC764 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count 20 pin microcontroller with 4 kbyte OTP |
| 87LPC767 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count 20 pin microcontroller with 4-kbyte OTP and 8-bit A/D converter |
| 87LPC768 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count 20 pin microcontroller with 4 kB OTP 8-bit A/D,and Pulse Width Modulator |
| 87LPC768FN | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 87LPC769 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count 20 pin microcontroller with 4 kB OTP 8-bit A/D, and DAC |
發布緊急采購，3分鐘左右您將得到回復。