
ADVANCE INFORMATION
17
83C196EA
— AUTOMOTIVE
6.0
ELECTRICAL CHARACTERISTICS
6.1
DC Characteristics
ABSOLUTE MAXIMUM RATINGS
Storage Temperature ..................................
–60°C to +150°C
Supply Voltage with Respect to V
SS
............... –0.5 V to +7.0 V
Power Dissipation .......................................................... 1.5 W
OPERATING CONDITIONS
T
C
(Case Temperature Under Bias)...............
–40°C to +125°C
V
CC
(Digital Supply Voltage) .............................. 4.5 V to 5.5 V
V
REF
(Analog Supply Voltage) ............................ 4.5 V to 5.5 V
F
XTAL
(Input frequency for V
= 4.5 V – 5.5 V)
(
Note 1
)................................................ 20 MHz to 40 MHz
NOTE:
1.
This device is static and should operate below
1 Hz, but has been tested only down to 20 MHz.
NOTICE
: This document contains information on
products in the design phase of development. The
specifications are subject to change without notice.
Verify with your local Intel sales office that you
have the latest datasheet before finalizing a
design.
WARNING
: Stressing the device beyond the
“Absolute Maximum Ratings” may cause perma-
nent damage. These are stress ratings only. Oper-
ation beyond the “Operating Conditions” is not
recommended and extended exposure beyond the
“Operating Conditions” may affect device
reliability.
Table 6. DC Characteristics at V
CC
= 4.5 V – 5.5 V (Sheet 1 of 2)
Symbol
Parameter
Min
Typical
(Note 1)
Max
Units
Test
Conditions
I
CC
V
CC
supply current
120
140
mA
XTAL1 = 40 MHz
V
CC
= 5.5 V
Device in Reset
I
IDLE
Idle mode current
60
100
mA
XTAL1 = 40 MHz
V
CC
= 5.5 V
V
CC
= 5.5 V
XTAL1 = 40 MHz
V
CC
= V
REF
= 5.5 V
Device in Reset
I
PD
I
REF
Powerdown mode current
50
μA
A/D reference supply cur-
rent
5
mA
I
CRVCC
Code RAM V
CC
Supply Cur-
rent
110
μA
V
CC
=5.5 V
I
INJD
Maximum injection current
per port on bidirectional pins
(
Note 4
)
–10
10
mA
NOTES:
1.
Typical values are based on a limited number of samples and are not guaranteed. The values listed are
at room temperature with V
= 5.0 V.
For P2.7:0, P3.7:0, P4.7:0, P5.7:0, P6.7:0, P10.3:0, P11.7:0, P12.4:0, AD15:0, EA#, RESET#, PLLEN,
NMI, TDI, TCLK, ONCE#, and XTAL1.
For P7.7:0, P8.7:0, P9.7:0, and P10.5:4.
The maximum injection current is not tested. The device is designed to meet this specification.
Pin capacitance is not tested. This value is based on design simulations.
2.
3.
4.
5.