參數資料
型號： 82801E
廠商： INTEL CORP
元件分類： 外設及接口
英文描述： Intel 82801E Communications I/O Controller Hub (C-ICH)
中文描述： MULTIFUNCTION PERIPHERAL, PBGA421
封裝： BGA-421
文件頁數： 49/84頁
文件大小： 1196K
代理商： 82801E
Intel
82801E C-ICH
Advance Information Datasheet
49
3.3
Pin Straps
3.3.1
Functional Straps
The following signals are used for static configuration. They are sampled at the rising edge of
PWROK to select configurations and then revert later to their normal usage. To invoke the
associated mode, the signal should be driven at least four PCI clocks prior to the time it is sampled.
3.3.2
Test Signals
3.3.2.1
Test Mode Selection
When PWROK is active (high), driving RTCRST# low for a number of PCI clocks (33 MHz) will
activate a particular test mode as specified in Table 28.
Note:
RTCRST# may be driven low any time after PCIRST is inactive. Refer to
“Testability” on page 77
for a detailed description of the 82801E C-ICH test modes.
Table 27. Functional Strap Definitions
Signal
Usage
When
Sampled
Comment
EE0_DOUT,
EE1_DOUT
Reserved
System designers should include a placeholder for a pull-down
resistor on EEn_DOUT but do not populate the resistor
GNT[A]#
Top-Swap
Override
Rising
Edge of
PWROK
The signal has a weak internal pull-up. If the signal is sampled low,
the system is strapped to the “Top-Swap” mode (82801E C-ICH will
invert A16 for all cycles targeting FWH BIOS space). The status of this
strap is readable via the Top-Swap bit (bit 13, D31: F0, Offset D4h).
Note that software will not be able to clear the Top-Swap bit until the
system is rebooted without GNT[A]# being pulled down.
HLCOMP
Enhanced
Hub
Interface
Mode
During
PCIRST#
assertion
If this signal is sampled high (via an external pull-up to VCC1_8), the
normal hub interface buffer mode will be selected. If this signal is
sampled low (via an external pull-down), the enhanced hub interface
buffer mode will be selected.
See the specific platform design guide for resistor values and routing
guidelines for each hub interface mode.
SPKR
No Reboot
Rising
Edge of
PWROK
The signal has a weak internal pull-up. If the signal is sampled low,
the system is strapped to the “No Reboot” mode (82801E C-ICH will
disable the TCO Timer system reboot feature). The status of this strap
is readable via the NO_REBOOT bit (bit 1, D31: F0, Offset D4h).
Table 28. Test Mode Selection
Number of PCI Clocks RTCRST# driven low after PWROK active
Test Mode
<4
No Test Mode Selected
4
XOR Chain 1
5
XOR Chain 2
6
XOR Chain 3
7
XOR Chain 4
相關PDF資料
PDF描述
82802AB Firmware Hub (FWH)
82802AC Firmware Hub (FWH)
8281 LNB SUPPLY AND CONTROL-VOLTAGE REGULATORS
8282 OCTAL LATCH
8282 LNB SUPPLY AND CONTROL-VOLTAGE REGULATORS
相關代理商/技術參數
參數描述
82801FB 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel I/O Controller Hub 6 (ICH6) Family
82801FBM 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel I/O Controller Hub 6 (ICH6) Family
82801FR 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel I/O Controller Hub 6 (ICH6) Family
82801GBICH7 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel I/O Controller Hub 7
82801GBMICH7-M 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel I/O Controller Hub 7
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*