參數資料
型號： ZL50233/GDG
廠商： ZARLINK SEMICONDUCTOR INC
元件分類： 數字傳輸電路
英文描述： DATACOM, ISDN ECHO CANCELLER, PBGA208
封裝： 17 X 17 MM, 1.30 MM HEIGHT, MO-192, LBGA-208
文件頁數： 3/38頁
文件大?。?/td> 547K
代理商： ZL50233/GDG
ZL50233
Data Sheet
11
Zarlink Semiconductor Inc.
In response to a valid disable tone, the echo canceller must be switched from the Enable Adaptation state to the
Bypass state. This can be done in two ways, automatically or externally. In automatic mode, the Tone Detectors
internally control the switching between Enable Adaptation and Bypass states. The automatic mode is activated by
setting the AutoTD bit in Control Register 2 to high. In external mode, an external controller is needed to service the
interrupts and poll the TD bits in the Status Registers. Following the detection of a disable tone (TD bit high) on a
given channel, the external controller must switch the echo canceller from Enable Adaptation to Bypass state.
1.6
Instability Detector
In systems with very low echo channel return loss (ERL), there may be enough feedback in the loop to cause
stability problems in the adaptive filter. This instability can result in variable pitched ringing or oscillation. Should this
ringing occur, the Instability Detector will activate and suppress the oscillations.
The Instability Detector is activated by setting the RingClr bit in Control Register 3 to “1”.
1.7
Narrow Band Signal Detector (NBSD)
Single or dual frequency tones (i.e. DTMF tones) present in the receive input (Rin) of the echo canceller for a
prolonged period of time may cause the Adaptive Filter to diverge. The Narrow Band Signal Detector (NBSD) is
designed to prevent this by detecting single or dual tones of arbitrary frequency, phase, and amplitude. When narrow
band signals are detected, adaptation is halted but the echo canceller continues to cancel echo.
The NBSD will be active regardless of the Echo Canceller functional state. However the NBSD can be disabled by
setting the NBDis bit to “1” in Control Register 2.
1.8
Offset Null Filter
Adaptive filters in general do not operate properly when a DC offset is present at any input. To remove the DC
component, the ZL50233 incorporates Offset Null filters in both Rin and Sin inputs.
The offset null filters can be disabled by setting the HPFDis bit to “1” in Control Register 2.
1.9
Adjustable Level Pads
The ZL50233 provides adjustable level pads at Rin, Rout, Sin and Sout. This setup allows signal strength to be
adjusted both inside and outside the echo path. Each signal level may be independently scaled with anywhere from
+9 dB to -12 dB level, in 3 dB steps. Level values are set using the Gains register.
CAUTION: Gain adjustment can help interface the ZL50233 to a particular system in order to provide optimum echo
cancellation, but it can also degrade performance if not done carefully. Excessive loss may cause low signal levels
and slow convergence. Exercise great care when adjusting these values. Also, due to internal signal routings in Back
to Back mode, it is not recommended that gain adjustments be used on Rin or Sout in this mode.
The -12 dB PAD bit in Control Register 1 is still supported as a legacy feature. Setting this bit will provide 12 dB of
attenuation at Rin, and override the values in the Gains register.
1.10
ITU-T G.168 Compliance
The ZL50233 has been certified G.168 (1997), (2000) and (2002) compliant in all 64 ms cancellation modes
(i.e. Normal and Back-to-Back configurations) by in-house testing with the DSPG ECT-1 echo canceller tester.
The ZL50233 has also been tested for G.168 compliance and all voice quality tests at AT&T Labs. The ZL50233
was classified as “carrier grade” echo canceller.
相關PDF資料
PDF描述
ZL50408GDC DATACOM, LAN SWITCHING CIRCUIT, PBGA208
ZL50408GDG2 DATACOM, LAN SWITCHING CIRCUIT, PBGA208
ZL50418GKG2 DATACOM, LAN SWITCHING CIRCUIT, PBGA553
ZL50418/GKC DATACOM, LAN SWITCHING CIRCUIT, PBGA553
ZL50418GKG2 DATACOM, LAN SWITCHING CIRCUIT, PBGA553
相關代理商/技術參數
參數描述
ZL50233QC 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:4 Channel Voice Echo Cancellor
ZL50233QCC 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:4 Channel Voice Echo Cancellor
ZL50233QCG1 制造商:Microsemi Corporation 功能描述:ECHO CANCELLER CHIP 4-CH G.165/G.168/G.711 W/ TONE DETECTION - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC VOICE ECHO CANCEL 4CH 100LQFP 制造商:Microsemi Corporation 功能描述:IC VOICE ECHO CANCEL 4CH 100LQFP
ZL50234 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:8 Channel Voice Echo Canceller
ZL50234/GDC 制造商:Microsemi Corporation 功能描述:ECHO Canceller Chip 8-CH G.164/G.165/G.168/G.711 With Tone Detection 208-Pin LBGA Tray 制造商:Microsemi Corporation 功能描述:ECHO CANCELLER CHIP 8CH G.164/G.165/G.168/G.711 W/ TONE DETE - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC VOICE ECHO CANCEL 8CH 208LBGA 制造商:Microsemi Corporation 功能描述:IC VOICE ECHO CANCEL 8CH 208LBGA
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*