- 您現在的位置：買賣IC網 > Datasheet目錄47 > XRP7714ILB-0X14-F (Exar Corporation)IC REG 5OUT BCK/LINEAR 40TQFN Datasheet資料下載
參數資料
| 型號： | XRP7714ILB-0X14-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 21/29頁 |
| 文件大?。?/td> | 1009K |
| 描述： | IC REG 5OUT BCK/LINEAR 40TQFN |
| 標準包裝： | 490 |
| 系列： | PowerXR |
| 拓?fù)洌?/td> | 降壓（降壓）同步（4），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 5 |
| 頻率 - 開關： | 1.5MHz |
| 電壓/電流 - 輸出 1： | 控制器 |
| 電壓/電流 - 輸出 2： | 控制器 |
| 電壓/電流 - 輸出 3： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 4.75 V ~ 25 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 40-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 40-TQFN（6x6） |
| 包裝： | 托盤 |
| 其它名稱： | 1016-1700 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
X
X
R
R
P
P
7
7
7
7
1
1
4
4
Q
Q
u
u
a
a
d
d
C
C
h
h
a
a
n
n
n
n
e
e
l
l
D
D
i
i
g
g
i
i
t
t
a
a
l
l
P
P
W
W
M
M
S
S
t
t
e
e
p
p
D
D
o
o
w
w
n
n
C
C
o
o
n
n
t
t
r
r
o
o
l
l
l
l
e
e
r
r
?2011 Exar Corporation
21/29
Rev. 1.1.6
The maximum duty cycle obtained from the table above is programmed by the PowerArchitect
TM
software into each of the channels using the SET_DUTY_LIMITER_CHx register. This ensures that
under all conditions (including faults), there will always be sufficient sampling time to measure the
output current. When the duty cycle limit is reached, the output voltage will no longer regulate and
will be clamped based on the maximum duty cycle limit setting.
It is possible for the user to program SET_DUTY_LIMITER_CHx register to a higher value, but the
OCP Fault and OCP WARN flags should then be ignored.
Efficiency
The PWM Switching frequency plays an important role on overall power conversion efficiency. As
the switching frequency increase, the switching losses also increase. Please see the APPLICATION
INFORMATION, Typical Performance Data for further examples.
Component Selection and Frequency
Typically the components become smaller as the frequency increases, as long as the ripple
requirements remain constant. At higher frequency the inductor can be smaller in value and have a
smaller footprint while still maintaining the same current rating.
FREQUENCY SYNCHRONIZATION FUNCTION AND EXTERNAL CLOCK
The user of the XRP7714 can choose to use an external source as the primary clock for the
XRP7714. This function can be configured using the SET_SYNC_MODE_CONFIG register. This
register sets the operation of the XRP7714 when an external clock is required. By selecting the
appropriate bit combination the user can configure the IC to function as a master or a slave when
two or more XRP7714s are used to convert power in a system. Automatic clock selection is also
provided to allow operation even if the external clock fails by switching the IC back to an internal
clock.
External Clock Synchronization
Even when configured to use an external clock, the chip initially powers up with its internal clock.
The user can set the percent target that the frequency detector will use when comparing the
internal clock with the clock frequency input on the GPIO pin. If the external clock frequency is
detected to be within the window specified by the user, then a switchover will occur to the external
clock. If the IC does not find a clock in the specified frequency target range then the external clock
will not be used and the IC will run on the internal clock that was specified by the user. If the
external clock fails the user can chose to have the internal clock take over, using the automatic
switch back mode in the SET_SYNC_MODE_CONFIG register.
XRP7714
Configured for
external clock use
CLK_IN
GPIO1
Fig. 27:XRP7714 Configured For External Clock Use
相關PDF資料 |
PDF描述 |
|---|---|
| XRP7740ILB-0X18-F | IC REG 5OUT BCK/LINEAR 40TQFN |
| XRP7740ILBTR-F | IC REG 5OUT BCK/LINEAR 40TQFN |
| ZDS1009TA | IC CURRENT MIRROR SOT223-8 |
| ZXCT1008FTA | IC CURRENT MONITOR 1% SOT23-3 |
| ZXCT1009T8TA | IC CURRENT MONITOR 1% SM8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRP7714ILB-0X18-F | 功能描述:電壓模式 PWM 控制器 4CH DIGITAL PWM CTRL I2C INTERFACE RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| XRP7714ILB-0X1C-F | 功能描述:電壓模式 PWM 控制器 4CH DIGITAL PWM CTRL I2C INTERFACE RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| XRP7714ILB-F | 功能描述:軟開關 PWM 控制器 4Ch Digital Pwr Cntr w/LDO prog. thru PC RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| XRP7714ILBTR-0X10-F | 制造商:EXAR 制造商全稱:EXAR 功能描述:Quad Channel Digital PWM Step Down Controller |
| XRP7714ILBTR-0X14-F | 制造商:EXAR 制造商全稱:EXAR 功能描述:Quad Channel Digital PWM Step Down Controller |
發布緊急采購，3分鐘左右您將得到回復。