- 您現在的位置：買賣IC網 > PDF目錄16531 > XR19L200IL32-0A-EB (Exar Corporation)EVAL BOARD FOR XR19L200 32QFN PDF資料下載
參數資料
| 型號： | XR19L200IL32-0A-EB |
| 廠商： | Exar Corporation |
| 文件頁數： | 4/40頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVAL BOARD FOR XR19L200 32QFN |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
XR19L200
12
SINGLE CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER
REV. 1.0.2
* After the trigger level is reached, an xoff character is sent after a short span of time (= time required to send 2 characters);
for example, after 2.083ms has elapsed for 9600 baud and 8-bit word length, no parity and 1 stop bit setting.
2.13
Special Character Detect
A special character detect feature is provided to detect an 8-bit character when bit-5 is set in the Enhanced
Feature Register (EFR). When this character (Xoff2) is detected, it will be placed in the FIFO along with normal
incoming RX data.
The L200 compares each incoming receive character with the programmed Xoff-2 data. If a match exists, the
received data will be transferred to the RX FIFO and ISR bit-4 will be set to indicate detection of special
character. Although the Internal Register Table shows Xon, Xoff Registers with eight bits of character
information, the actual number of bits is dependent on the programmed word length. Line Control Register
(LCR) bits 0-1 defines the number of character bits, i.e., either 5 bits, 6 bits, 7 bits, or 8 bits. The word length
selected by LCR bits 0-1 also determines the number of bits that will be used for the special character
comparison. Bit-0 in the Xon, Xoff Registers corresponds with the LSB bit for the receive character.
2.14
Sleep Modes with Wake-Up Interrupt
There are two levels of power management integrated in the L200. The device is low power with low
operational and standby supply currents. In the Partial Sleep mode, the internal oscillator of the UART or
charge pump of the RS-232 transceiver is turned off to reduce the power consumption. In the Full Sleep mode,
both the oscillator and the charge pump are turned off.
2.14.1
Partial Sleep Mode
There are two different partial sleep modes. In the first mode, the UART is in sleep mode and the RS-232
transceiver is active. In the other mode, the UART is active but the charge pump of the RS-232 transceiver is
turned off.
2.14.1.1
UART in sleep mode, RS-232 transceiver active
If the ACP pin is LOW, then the charge pump for the RS-232 transceiver will always be active. But the UART
portion in the L200 can still enter sleep mode if all of these conditions are satisfied:
■ no interrupts pending (ISR bit-0 = 1)
■ the 16-bit divisor programmed in DLM and DLL registers is a non-zero value
■ sleep mode is enabled (IER bit-4 = 1)
■ RXD input pin is idling LOW
The L200 stops its crystal oscillator to conserve power in this mode. The user can check the XTAL2 pin for no
clock output as an indication that the device has entered the partial sleep mode.
The UART portion in the L200 resumes normal operation or active mode by any of the following:
■ a receive data start bit transition on the RXD input (LOW to HIGH)
■ a data byte is loaded to the transmitter, THR or FIFO
The UART portion in the L200 will return to the sleep mode automatically after all interrupting conditions have
been serviced and cleared. In any case, the sleep mode will not be entered while an interrupt is pending. The
UART portion of the L200 will stay in the sleep mode of operation until it is disabled by setting IER bit-4 to a
logic 0.
TABLE 4: AUTO XON/XOFF (SOFTWARE) FLOW CONTROL
RX TRIGGER LEVEL
INT PIN ACTIVATION
XOFF CHARACTER(S) SENT
(CHARACTERS IN RX FIFO)
XON CHARACTER(S) SENT
(CHARACTERS IN RX FIFO)
1
1*
0
4
4*
1
8
8*
4
14
14*
8
相關PDF資料 |
PDF描述 |
|---|---|
| 6374611-1 | C/A 2.0MM SM LC-SC 1M1 |
| RBC15DCST-S288 | CONN EDGECARD 30POS .100 EXTEND |
| VI-JTV-EZ-S | CONVERTER MOD DC/DC 5.8V 25W |
| AD8016ARE-EVAL | BOARD EVAL FOR AD8016ARE |
| UPJ0J681MPD1TD | CAP ALUM 680UF 6.3V 20% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR19L200IL32-0B-EB | 功能描述:界面開發工具 Supports L200 32 pin QFN, PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XR19L200IL32-F | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR19L202 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER |
| XR19L202IL48 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER |
| XR19L202IL48-0B-EB | 功能描述:界面開發工具 Supports L202 48 pin QFN,PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
發布緊急采購，3分鐘左右您將得到回復。