- 您現在的位置：買賣IC網 > PDF目錄4004 > XPC850DEVR66BU (Freescale Semiconductor)IC MPU POWERQUICC 66MHZ 256-PBGA PDF資料下載
參數資料
| 型號： | XPC850DEVR66BU |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 10/72頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MPU POWERQUICC 66MHZ 256-PBGA |
| 標準包裝： | 60 |
| 系列： | MPC8xx |
| 處理器類型： | 32-位 MPC8xx PowerQUICC |
| 速度： | 66MHz |
| 電壓： | 3.3V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 256-LBGA |
| 供應商設備封裝： | 256-PBGA（23x23） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
MPC850 PowerQUICC Integrated Communications Processor Hardware Specifications, Rev. 2
18
Freescale Semiconductor
Bus Signal Timing
B42
CLKOUT rising edge to TS valid
(hold time)
2.00
—
2.00
—
2.00
—
50.00
ns
B43
AS negation to memory
controller signals negation
—TBD
TBD
—
50.00
ns
1
The minima provided assume a 0 pF load, whereas maxima assume a 50pF load. For frequencies not marked on
the part, new bus timing must be calculated for all frequency-dependent AC parameters. Frequency-dependent AC
parameters are those with an entry in the FFactor column. AC parameters without an FFactor entry do not need to
be calculated and can be taken directly from the frequency column corresponding to the frequency marked on the
part. The following equations should be used in these calculations.
For a frequency F, the following equations should be applied to each one of the above parameters:
For minima:
For maxima:
where:
D is the parameter value to the frequency required in ns
F is the operation frequency in MHz
D50 is the parameter value defined for 50 MHz
CAP LOAD is the capacitance load on the signal in question.
FFACTOR is the one defined for each of the parameters in the table.
2
Phase and frequency jitter performance results are valid only if the input jitter is less than the prescribed value.
3
If the rate of change of the frequency of EXTAL is slow (i.e. it does not jump between the minimum and maximum
values in one cycle) or the frequency of the jitter is fast (i.e., it does not stay at an extreme value for a long time) then
the maximum allowed jitter on EXTAL can be up to 2%.
4
The timing for BR output is relevant when the MPC850 is selected to work with external bus arbiter. The timing for
BG output is relevant when the MPC850 is selected to work with internal bus arbiter.
5
The setup times required for TA, TEA, and BI are relevant only when they are supplied by an external device (and
not when the memory controller or the PCMCIA interface drives them).
6
The timing required for BR input is relevant when the MPC850 is selected to work with the internal bus arbiter. The
timing for BG input is relevant when the MPC850 is selected to work with the external bus arbiter.
7
The D[0–31] and DP[0–3] input timings B20 and B21 refer to the rising edge of the CLKOUT in which the TA input
signal is asserted.
8
The D[0:31] and DP[0:3] input timings B20 and B21 refer to the falling edge of CLKOUT. This timing is valid only for
read accesses controlled by chip-selects controlled by the UPM in the memory controller, for data beats where DLT3
= 1 in the UPM RAM words. (This is only the case where data is latched on the falling edge of CLKOUT.
9
The timing B30 refers to CS when ACS = '00' and to WE[0:3] when CSNT = '0'.
10 The signal UPWAIT is considered asynchronous to CLKOUT and synchronized internally. The timings specified in
B37 and B38 are specified to enable the freeze of the UPM output signals.
11 The AS signal is considered asynchronous to CLKOUT.
Table 6. Bus Operation Timing 1 (continued)
Num
Characteristic
50 MHz
66 MHz
80 MHz
FFACT
Cap Load
(default
50 pF)
Unit
Min
Max
Min
Max
Min
Max
D =
FFACTOR x 1000
F
(D50 - 20 x FFACTOR)
+
D =
FFACTOR x 1000
F
(D50 -20 x FFACTOR)
++
1ns(CAP LOAD - 50) / 10
相關PDF資料 |
PDF描述 |
|---|---|
| IDT70V9089L9PF | IC SRAM 512KBIT 9NS 100TQFP |
| XPC850DEVR50BUR2 | IC MPU POWERQUICC 50MHZ 256-PBGA |
| IDT70V9089L12PFI | IC SRAM 512KBIT 12NS 100TQFP |
| XPC850DECVR66BU | IC MPU POWERQUICC 66MHZ 256-PBGA |
| IDT709379L9PF | IC SRAM 576KBIT 9NS 100TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XPC850DEVR66BUR2 | 功能描述:IC MPU POWERQUICC 66MHZ 256-PBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC8xx 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| XPC850DEVR80BU | 功能描述:IC MPU POWERQUICC 80MHZ 256-PBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC8xx 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| XPC850DEZT50B | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Communications Controller Hardware Specifications |
| XPC850DEZT50BT | 功能描述:IC POWER PC MPU 80MHZ 256-PBGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC8xx 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| XPC850DEZT50BU | 功能描述:IC MPU POWERQUICC 50MHZ 256-PBGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC8xx 標準包裝:1 系列:MPC85xx 處理器類型:32-位 MPC85xx PowerQUICC III 特點:- 速度:1.2GHz 電壓:1.1V 安裝類型:表面貼裝 封裝/外殼:783-BBGA，F(xiàn)CBGA 供應商設備封裝:783-FCPBGA（29x29） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。