參數資料
型號: UPD75P3018AGK-BE9
廠商: NEC Corp.
英文描述: LJT 46C 40#20 4#16 2#8(COAX)
中文描述: 4位單片機
文件頁數: 29/64頁
文件大?。?/td> 356K
代理商: UPD75P3018AGK-BE9
PD75P3018A
35
Data Sheet U11917EJ2V0DS00
Main System Clock Oscillator Characteristics (TA = –40 to +85
°C, VDD = 1.8 to 5.5 V)
Resonator
Recommended Circuit
Parameter
Conditions
MIN.
TYP.
MAX.
Unit
Ceramic
Oscillation frequency
1.0
6.0Note 2
MHz
resonator
(fX)Note 1
Oscillation
After VDD has
4
ms
stabilization timeNote 3
reached MIN. value
of oscillation voltage
range
Crystal
Oscillation frequency
1.0
6.0Note 2
MHz
resonator
(fX)Note 1
Oscillation
VDD = 4.5 to 5.5 V
10
ms
stabilization timeNote 3
30
External
X1 input frequency
1.0
6.0Note 2
MHz
clock
(fX)Note 1
X1 input high-/
83.3
500
ns
low-level width
(tXH, tXL)
Notes 1. The oscillation frequency and X1 input frequency shown above indicate characteristics of the oscillator only.
For the instruction execution time, refer to AC Characteristics.
2. If the oscillation frequency is 4.19 MHz < fX
≤ 6.0 MHz at 1.8 V ≤ VDD < 2.7 V, do not select processor clock control
register (PCC) = 0011. If PCC = 0011, one machine cycle is less than 0.95
s, falling short of the rated value
of 0.95
s.
3. The oscillation stabilization time is the time required for oscillation to be stabilized after VDD has been applied
or STOP mode has been released.
Caution
When using the main system clock oscillator, wire the portion enclosed in the broken line in the above
figure as follows to prevent adverse influence due to wiring capacitance:
Keep the wiring length as short as possible.
Do not cross the wiring with other signal lines.
Do not route the wiring in the vicinity of a line through which a high alternating current flows.
Always keep the ground point of the capacitor of the oscillator at the same potential as VDD.
Do not ground to a power supply pattern through which a high current flows.
Do not extract signals from the oscillator.
Remark
For the resonator selection and oscillator constant, customers are requested to either evaluate the oscillation
themselves or apply to the resonator manufacturer for evaluation.
X1
X2
C1
C2
VDD
X1
X2
C1
C2
VDD
X1
X2
相關PDF資料
PDF描述
UPD780023AGK-xxx-9ET Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Pin; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No
UPD78011HGK-XXX-8A8 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP64
UPD78053GC-XXX-8BT 8-BIT, MROM, 5 MHz, MICROCONTROLLER, PQFP80
UPD78322GJ-XXX-5BJ 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP74
UPD789132GS-XXX 8-BIT, MROM, MICROCONTROLLER, PDSO30
相關代理商/技術參數
參數描述
UPD75P3036GC-3B9-A 制造商:Renesas Electronics Corporation 功能描述:
UPD75P308GF-3B9 制造商:Renesas Electronics Corporation 功能描述:MCU 4-Bit 75XL CISC 8064Byte PROM 5V 80-Pin PQFP
UPD75P308GF-3BA 制造商:Renesas Electronics Corporation 功能描述:
UPD75P308GF-3BA-A 制造商:Renesas Electronics Corporation 功能描述:
UPD75P3116GC-8BS-A 制造商:Renesas Electronics Corporation 功能描述:MCU 4-bit 75XL CISC 16KB EPROM 2.5V/3.3V/5V 64-Pin LQFP