參數資料
型號： TSS463-AAR
廠商： ATMEL CORP
元件分類： 微控制器/微處理器
英文描述： VAN Data Link Controller with Serial Interface
中文描述： 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDSO16
封裝： SOP-16
文件頁數： 39/60頁
文件大?。?/td> 816K
代理商： TSS463-AAR
39
TSS463-AA
4205B–AUTO–12/04
Identifier Tag and Command
Registers
The identifier tag and command registers are located at the base_address and
base_address + 1. It allows the user to specify the full 12-bit identifier field of the ISO
standard and the 4-bit command.
Read/Write registers.
ID_T [11:0]: Identifier Tag
Upon a reception hit (i.e, a good comparison between the identifier received and an
identifier specified, taking the comparison mask into account, as well as a status and
command indicating a message to be received), the identifier tag bits value will be
rewritten with the identifier bits actually received.
EXT, RAK, RNW and RTR
(See Section “Message Types”, page 45). No comparison will be done on the command
bits, except on EXT bit. The RAK, RNW and RTR bits will be written into the first byte of
the Message upon a reception hit.
The RNW and RTR bits, as well as the status bits in the length and status register, must
be in a valid position for reception or transmission. If not, the message corresponding to
this identifier is considered as inactive or invalid.
The way of knowing if an acknowledge sequence was requested or not is to check the
first byte of the Message.
Message Pointer Register
The message pointer register at address (base_address + 0x02) is 8 bits wide. It indi-
cates where in the Message DATA RAM area the message buffer is located.
Read/Write register.
DRAK: Disable RAK (Used in
‘Spy Mode’)
In reception: whatever is the RAK bit of the incoming valid frame, no ACK answer will be
set. If the message was successfully received, an IT is set (ROK or RNOK).
In transmission: no action.
One
: disable active, “spy mode”.
Zero
: disable inactive, normal operation.
M_P [6:0]: Message Pointer
Since the Message DATA RAM area base address is 0x80, the value in this register is
the offset from that address. If the message buffer length value is illegal (i.e. zero), this
register is redefined as being a link pointer, thus containing the channel number of the
channel that contains the actual message pointer, message length and received status.
However, the identifier, mask, error and transmitted status used will be that of the origi-
nally matched channel. In any case, if a link is intended, the three high bits of M_P [6:0]
should be set to 0.
7
6
5
4
3
2
1
0
ID_T 3
ID_T 2
ID_T 1
ID_T 0
EXT
RAK
RNW
RTR
base_address
+ 0x01
7
6
5
4
3
2
1
0
ID_T 11
ID_T 10
ID_T 9
ID_T 8
ID_T 7
ID_T 6
ID_T 5
ID_T 4
base_address
+ 0x00
7
6
5
4
3
2
1
0
DRAK
M_P 6
M_P 5
M_P 4
M_P 3
M_P 2
M_P 1
M_P 0
base_address
+ 0x02
相關PDF資料
PDF描述
TSS463A-TERZ VAN Data Link Controller with Serial Interface
TSS463C VAN Data Link Controller with Serial Interface
TSS4B02G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B03G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B01G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
相關代理商/技術參數
參數描述
TSS463A-TERZ 功能描述:網絡控制器與處理器 IC ASICS RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
TSS463B 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Serial VAN Data Link Controller
TSS463B_03 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Serial VAN Data Link Controller
TSS463B_04 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface
TSS463B-TERA 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*