參數資料
型號： TSS461CR
英文描述： LAN Node Controller
中文描述： 網絡節點控制器
文件頁數： 19/52頁
文件大?。?/td> 268K
代理商： TSS461CR
TSS461C
19
Rev. D (22 Feb 01)
Transmission diagnosis
The transmission compares RxD1 and RxD2 inputs (through the input comparators and the filters) with the data
transmitted on TxD output.
At a time when the transmission logic generates a dominant - recessive transition, the inputs can give different
values. Taking into account the filtering delay, the bus line seen as dominant is assumed to be correct, the other one,
recessive, is considered faulty. The diagnosis mode is changed to reflect that.
Protocol fault
The protocol fault is detected by counting the number of consecutive dominant timeslots.
If eight consecutive timeslots are dominant, the diagnosis mode will change to the major error mode.
8.3. Generation of Internal Signals
8.3.1. RI Signal (Return to Idle)
This signal is used to return to nominal mode in the three specified selection modes (see sections 8.1. and 8.4.). The
RI signal is disabled in automatic selection mode.
The RI signal is a pulse generated when an EOF is detected. So, at the end of each frame, the user, regarding the
diagnosis status bit Sa, Sb & Sc, can make its own choice.
8.3.2. SDC Signal (Synchronous Diagnosis Clock)
This time base is used by diagnosis system in automatic selection mode (see section 8.4. ) when no event is recorded
on the bus.
The SDC is generated either by a special SDC divider connected to the timeslot clock, either manually. The SDC clock
period must be long compared to the timeslot duration.
A typical SDC period should be greater than the maximum frame length appearing on the VAN network.
8.3.3. TIP Signal (Transmission In Progress)
This signal must be enabled to allow the transmission diagnosis (see section 8.2.2.).
The TIP turns on synchronously with the beginning of the transmission:
for asynchronous bus access, the beginning of SOF,
for synchronous bus access, the beginning of the identifier field,
for a requestee of in frame reply, the RTR bit of the command field.
The TIP turns off synchronously with the end of the transmission:
after EOF
after a losing of arbitration or a code violation detection
for a requestor of in frame reply, when the arbitration is lost on RTR the bit.
This signal is not generated when the transmission logic only sends an ACK.
相關PDF資料
PDF描述
TSS463-AA TSS463-AA [Updated 3/03. 60 Pages]
TSS463D Industrial Control IC
TSS463R Industrial Control IC
TSS461E VAN Data Link Controller
TSS461E-TDRA-9 VAN Data Link Controller
相關代理商/技術參數
參數描述
TSS461C-TDRZ 功能描述:網絡控制器與處理器 IC ASICS RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
TSS461CVAN 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:Van Controller Serial Interface
TSS461E 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller
TSS461E_06 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller
TSS461E-TDRA-9 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*