- 您現在的位置：買賣IC網 > Datasheet目錄47 > TPS24711DGSR (Texas Instruments)IC CTRLR HOT SWAP 2.5-18V 10MSOP Datasheet資料下載
參數資料
| 型號： | TPS24711DGSR |
| 廠商： | Texas Instruments |
| 文件頁數： | 15/34頁 |
| 文件大小： | 2792K |
| 描述： | IC CTRLR HOT SWAP 2.5-18V 10MSOP |
| 標準包裝： | 1 |
| 類型： | 熱交換控制器 |
| 應用： | 通用 |
| 內部開關： | 無 |
| 電流限制： | 可調 |
| 電源電壓： | 2.5 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 標準包裝 |
| 其它名稱： | 296-28562-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
TPS24710,TPS24711
TPS24712,TPS24713
www.ti.com
SLVSAL2E JANUARY 2011REVISED NOVEMBER 2013
Figure 26. Inrush Mode at Hot-Swap Circuit Insertion
INRUSH OPERATION
After TPS24710/11/12/13 initialization is complete (as described in the Board Plug-In section) and EN is active,
GATE is enabled (V
GATE
starts increasing). When V
GATE
reaches the MOSFET M1 gate threshold, a current flows
into the downstream bulk storage capacitors. When this current exceeds the limit set by the power limit engine,
the gate of the MOSFET is regulated by a feedback loop to make the MOSFET current rise in a controlled
manner. This not only limits the inrush current charging capacitance but it also limits the power dissipation of the
MOSFET to safe levels. A more complete explanation of the power limiting scheme is given in the section
entitled Action of the Constant Power Engine. When Gate is enabled, the TIMER pin begins to charge the timing
capacitor C
T
with a current of approximately 10 糀. The TIMER pin continues to charge C
T
until V
(GATE VCC)
reaches the timer activation voltage (5.9 V for V
VCC
= 12 V). The TIMER then begins to discharge C
T
with a
current of approximately 10 糀. This indicates that the inrush mode is finished. If the TIMER exceeds its upper
threshold of 1.35 V before V
(GATE VCC)
reaches the timer activation voltage, the GATE pin is pulled to GND and
the hot-swap circuit enters either latch mode (TPS24710/12) or auto-retry mode (TPS24711/13).
The power limit feature is disabled once the inrush operation is finished and the hotswap circuit becomes a
circuit breaker. The TPS24710/11/12/13 will turn off the MOSFET, M1, after a fault timer period once the load
exceeds the current limit threshold.
ACTION OF THE CONSTANT-POWER ENGINE
Figure 27 illustrates the operation of the constant-power engine during start-up. The circuit used to generate the
waveforms of Figure 27 was programmed to a power limit of 29.3 W by means of the resistor connected between
PROG and GND. At the moment current begins to flow through the MOSFET, a voltage of 12 V appears across
it (input voltage V
VCC
= 12 V), and the constant-power engine therefore allows a current of 2.44 A (equal to 29.3
W divided by 12 V) to flow. This current increases in inverse ratio as the drain-to-source voltage diminishes, so
as to maintain a constant dissipation of 29.3 W. The constant-power engine adjusts the current by altering the
reference signal fed to the current limit amplifier. The lower part of Figure 28 shows the measured power
Copyright ?20112013, Texas Instruments Incorporated
Submit Documentation Feedback
15
Product Folder Links: TPS24710 TPS24711 TPS24712 TPS24713
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2491DGSG4 | IC POS HV HOT-SWAP CTRLR 10-MSOP |
| W83772G | IC H/W MONITOR 8-TSSOP |
| W83L786G | IC H/W MONITOR 28-SSOP |
| X96011V14IZ | IC SENSOR TEMP BIAS SGL 14-TSSOP |
| XR4151CP-F | IC CONV VF/FV 8PDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS24711EVM-004 | 功能描述:電源管理IC開發工具 TPS24711 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS24712DGS | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Pwr- Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24712DGSR | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Pwr- Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24713DGS | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Hot- Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24713DGSR | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Hot- Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。