- 您現在的位置：買賣IC網 > PDF目錄69494 > TLE7242-2G (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, PDSO28 PDF資料下載
參數資料
| 型號： | TLE7242-2G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 封裝： | GREEN, PLASTIC, DSO-28 |
| 文件頁數： | 13/50頁 |
| 文件大小： | 1210K |
| 代理商： | TLE7242-2G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
TLE7242-2G
Functional Description and Electrical Characteristics
Data Sheet
20
Rev. 1.0, 2008-07-09
Figure 13
Open - On
5.3.2
Off-State Diagnostics
The off-state diagnostics function in both constant current mode and in on/off mode.
When the OUTx pin transitions low, the fault timers are cleared to 0 and the tested timer starts to count up. If the
tested timer expires, the Bit OFF-T in the FAULT register is set. If a SPI fault register read occurs, the tested timer
is cleared to 0 and starts again to count up. If the OUTx pin transitions high, the tested-timer is cleared to zero and
then used for on-state diagnostics.
If the analog OL fault signal (OL-FA) changes to 1, the fault filter timer starts to count up. If the fault filter timer
expires, the digitally filtered OL fault signal (OL-ON-FD) is set to one.
If OL-FA changes to 0, OL-FD changes immediately to 0 and the fault filter timer is cleared to 0.
If the analog SG fault signal (SG-FA) changes to 1, the fault filter timer is cleared to 0 and starts to count up. If the
fault filter timer expires, the digitally filtered SG fault signal (SG-FD) is set to one. If SG-FA changes to 0, SG-FD
changes immediately to 0 and the fault filter timer is cleared to 0.
If SG-FD = 1 and the tested timer is expired then the SG-F bit in the FAULT register is set and the OL-OFF-F bit
in the FAULT register remains unchanged (independently from OL-OFF-FD).
If SG-FD = 0 and OL-OFF-FD = 1 then the OL-F Bit in the FAULT register is set.
If a SPI fault read occurs, the OFF-T Bit, the SG-F Bit and the OL-F Bit in the SPI registers are cleared to zero
(and the timers are cleared to 0).
PWM_Start
OUTx
Vpos
OL-ON-F
SPI Message
Diagnostic Read
64 * PWM period
相關PDF資料 |
PDF描述 |
|---|---|
| TLE8242 | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| TLE8386EL | 0.09 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLI4946-2L | MAGNETIC SENSOR, PSIP3 |
| TLI4946K | MAGNETIC SENSOR, PDSO3 |
| TLV431AIDBVR | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE72422GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Constant Current Control 28-Pin DSO 制造商:Infineon Technologies AG 功能描述:TRANSMISSION_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC CURRENT SOURCE DSO28 |
| TLE7243SL | 功能描述:電源開關 IC - 配電 MC RELAY + LED RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| TLE7243SLFUMA1 | 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED - Tape and Reel |
| TLE7243SLXUMA2 | 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 24-Pin SSOP 制造商:Infineon Technologies AG 功能描述:IC DRIVER SPI 8CH LS 24SSOP |
| TLE7244SL | 功能描述:電源開關 IC - 配電 MC RELAY + LED RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。