- 您現在的位置：買賣IC網 > PDF目錄69494 > TLE7242-2G (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, PDSO28 PDF資料下載
參數資料
| 型號： | TLE7242-2G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 封裝： | GREEN, PLASTIC, DSO-28 |
| 文件頁數： | 11/50頁 |
| 文件大?。?/td> | 1210K |
| 代理商： | TLE7242-2G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
Data Sheet
19
Rev. 1.0, 2008-07-09
TLE7242-2G
Functional Description and Electrical Characteristics
5.3.1
On-State Diagnostics
When the OUTx pin transitions high, the fault timers are cleared to 0 and the tested timer starts. If the tested timer
expires, the Bit SB-T (in the SPI register #9) is set to 1. If the OUTx pin transitions low, the tested timer is cleared
and then used for the off-state diagnostics.
If the analog SB fault signal (SB-FA) changes to 1, the fault filter timer starts. If the fault filter timer expires, the
digitally filtered SB fault signal (SB-FD) is set to one. If SB-FA changes to 0, SB-FD changes immediately to 0 and
the filter timer is cleared to 0.
A SB-FD=1 and SB-T=1 switches off the OUTx signal and the SB-F bit in the FAULT register will be set. The OUTx
pin remains in the off state until the fault retry PWM period counter expires.
If the SPI fault register is read, then the SB-F bit and the SB-FT bit in the FAULT register are cleared. Also, the
tested timer is cleared to 0.
The Short to Battery (SB) detection functions in both on/off and constant current mode. The SG-FD and OL-OFF-
FD signals are held to 0 while the OUTx pin is high.
If the TLE7242 2G IC is in ON/OFF mode, Open Load ON detection is disabled (OL-ON-F = 0).
If the TLE7242 2G IC is not in ON/OFF mode and the OUTx pin is high for 64 PWM periods, then open load fault
ON mode is detected and the OL-ON-F bit in the FAULT register is set. This bit will be cleared when a SPI fault
read occurs. If the OUTx pin remains in a high state, then the open load - on fault condition is detected again after
another 64 PWM cycles.
Figure 12
On-State Diagnostic Timing - Short to Vbat
PWM_Start
OUTx
Vpos
Load
Current
SB-T
SB-F
SPI READ
ADDR 9
Tested
Timer
Fault
Filter
Fault Retry Time
(Address #8)
Short to Vbat
Load
ok
short
Vsb
Tested
Timer
Fault
Filter
相關PDF資料 |
PDF描述 |
|---|---|
| TLE8242 | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| TLE8386EL | 0.09 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLI4946-2L | MAGNETIC SENSOR, PSIP3 |
| TLI4946K | MAGNETIC SENSOR, PDSO3 |
| TLV431AIDBVR | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE72422GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Constant Current Control 28-Pin DSO 制造商:Infineon Technologies AG 功能描述:TRANSMISSION_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC CURRENT SOURCE DSO28 |
| TLE7243SL | 功能描述:電源開關 IC - 配電 MC RELAY + LED RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| TLE7243SLFUMA1 | 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED - Tape and Reel |
| TLE7243SLXUMA2 | 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 24-Pin SSOP 制造商:Infineon Technologies AG 功能描述:IC DRIVER SPI 8CH LS 24SSOP |
| TLE7244SL | 功能描述:電源開關 IC - 配電 MC RELAY + LED RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。