- 您現在的位置：買賣IC網 > PDF目錄385929 > TLC34076-85 (Texas Instruments, Inc.) Color-Palette(85MHz,與TLC34075兼容，另具24位和16位真彩色模式) PDF資料下載
參數資料
| 型號： | TLC34076-85 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Color-Palette(85MHz,與TLC34075兼容，另具24位和16位真彩色模式) |
| 中文描述： | 顏色調色板（85MHz，與TLC34075兼容，另具24位和16位真彩色模式） |
| 文件頁數： | 11/56頁 |
| 文件大小： | 419K |
| 代理商： | TLC34076-85 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
1-5
1.5 Terminal Functions
PIN NAME
BLANK,
VGABLANK
NO.
I/O
I
DESCRIPTION
60, 61
Blanking inputs. Two blanking inputs are provided in order to remove any
external multiplexing of the signals that may cause data and blank to skew.
When the VGA pass-through mode is set in the mux control register, the
VGABLANK input is used for blanking; otherwise, BLANK is used.
Dot clock inputs. Any of the three clocks can be used to drive the dot clock
at frequencies up to 135 MHz. When VGA pass-through mode is active, CLK0
is used by default.
Dual-mode dot clock input. This input is an ECL-compatible input, but a TTL
clock may be used on either CLK3 or CLK3 if so selected in the input clock
selection register. This input may be selected as the dot clock for any
frequency of operation up to the device limit. It can also be used with a
single-ended ECL clock source if the unused input is externally terminated to
provide the proper common mode level.
Compensation input. This terminal provides compensation for the internal
reference amplifier. A resistor (optional) and ceramic capacitor are required
between this terminal and VDD. The resistor and capacitor must be as close
to the device as possible to avoid noise pickup. Refer to Appendix B for more
details.
MPU interface data bus. Used to transfer data in and out of the register map
and palette/overlay RAM.
Full-scale adjustment pin. A resistor connected between this pin and ground
controls the full-scale range of the DACs.
Ground. All GND pins must be connected. The analog and digital GND pins
are connected internally.
Horizontal and vertical sync outputs of the true/complement gate mentioned
in the HSYNC, VSYNC description below (see Section 2.8).
Horizontal and vertical sync inputs. These signals are used to generate the
sync level on the green current output. They are active-low inputs for the
normal modes and are passed through a true/complement gate. For the VGA
pass-through mode, they are passed through to HSYNCOUT and
VSYNCOUT without polarity change as specified by the control register (see
Section 2.8).
Analog current outputs. These outputs can drive a 37.5-
load directly
(doubly terminated 75-
line), thus eliminating the need for any external
buffering.
MUX output control. This output pin is software programmable. It is set low
to indicate to external devices that VGA pass-through mode is being used
when the MUX control register value is set to 2Dh. If bit 7 of the general control
register is set high after the mode is set, this output goes high. This pin is only
used for external control; it affects no internal circuitry.
Pixel input port. This port can be used in various modes as shown in the MUX
control register. It is recommended that unused pins be tied to ground. It also
supports Little/Big Endian data formats. All the unused pins must be tied to
GND.
Read strobe input. A low logic level on this pin initiates a read from the
TLC34076 register map. Reads are performed asynchronously and are
initiated on the falling edge of RD (see Figure 3–1).
CLK<0:2>
77, 76, 75
I
CLK3, CLK3
74, 73
I
COMP
52
I
D<0:7>
36–43
I/O
FS ADJUST
51
I
GND
44, 54,
56, 80
46, 47
HSYNCOUT,
VSYNCOUT
HSYNC, VSYNC
O
58, 59
I
IOR, IOG, IOB
48, 49, 50
O
MUXOUT
63
O
P<0:31>
29–1,
84–82
I
RD
31
I
相關PDF資料 |
PDF描述 |
|---|---|
| TLC34076-170 | Color-Palette(170MHz,與TLC34075兼容，另具24位和16位真彩色模式) |
| TLC34076M-135 | Color-Palette(135MHz,與TLC34075兼容，另具24位和16位真彩色模式) |
| TLC4501(中文) | Self-Calibrating Dual Operational Amplifier(先進LINEPIC，自校準精密運放) |
| TLC4502(中文) | Self-Calibrating Operational Amplifier(先進LINEPIC，雙組自校準精密運放) |
| TLC540(中文) | 8-Bit Analog-To-Digital Converters With Serial Control And 11 Inputs(串行控制，75ksps,12通道，8位ADC) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLC34076-85FN | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
| TLC34077 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Video Interface Palette Data Manual |
| TLC34077135FN | 制造商:TI 功能描述:* |
| TLC352 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:LinCMOSE DUAL DIFFERENTIAL COMPARATOR |
| TLC352CD | 功能描述:校驗器 IC Dual Differential RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。