- 您現在的位置：買賣IC網 > PDF目錄372454 > TISP61089BD (Electronic Theatre Controls, Inc.) TISP61089B High Voltage Ringing SLIC Protector PDF資料下載
參數資料
| 型號： | TISP61089BD |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | TISP61089B High Voltage Ringing SLIC Protector |
| 中文描述： | TISP61089B高壓振鈴用戶接口保護 |
| 文件頁數： | 6/22頁 |
| 文件大?。?/td> | 411K |
| 代理商： | TISP61089BD |
OCTOBER 2000 - REVISED FEBRUARY 2005
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
TISP61089B High Voltage Ringing SLIC Protector
APPLICATIONS INFORMATION
Operation of Ringing SLICs using Multiple Negative Voltage Supply Rails
Figure 4 shows a typical powering arrangement for a multi-supply rail SLIC. VBATL is a lower (smaller) voltage supply than VBATH. With supply
switch S1 in the position shown, the line driver amplifiers are powered between 0 V and VBATL. This mode minimizes the power consumption
for short loop transmission. For long loops and to generate ringing, the driver voltage is increased by operating S1 to connect VBATH. These
conditions are shown in Figure 5.
SLIC
Figure 4. SLIC with Voltage Supply Switching
S1
LINE
DRIVERS
V
BATH
0 V
AI6XCC
SUPPLY
SWITCH
LINE
V
BATL
Figure 5. Driver Supply Voltage Levels
0 V
0 V
V
BATL
SHORT LOOP
V
BATH
LONG LOOP
V
DCRING
V
SLICG
V
PKRING
/2
V
SLICH
AI6XCD
V
BATH
V
BATH
RINGING
V
PKRING
/2
V
PKRING
/2
V
PKRING
/2
0 V
Conventional ringing is typically unbalanced ground or battery backed. To minimize the supply voltage required, most multi-rail SLICs use
balanced ringing as shown in Figure 5. The ringing has d.c., V
DCRING
, and a.c., V
PKRING
, components. A 70 V r.m.s. a.c. sinusoidal ring signal
has a peak value, V
PKRING
, of 99 V. If the d.c. component was 20 V, then the total voltage swing needed would be 99 + 20 = 119 V. There are
internal losses in the SLIC from ground, V
SLICG
, and the negative supply, V
SLICH
. The sum of these two losses generally amounts to a total of
10 V. This makes a total, V
BATH
, supply rail value of 119 + 10 = 129 V.
In some cases a trapezoidal a.c. ring signal is used. This would have a peak to r.m.s ratio (crest factor) of about 1.25, increasing the r.m.s. a.c.
ring level by 13 %. The d.c. ring voltage may be lowered for short loop applications.
相關PDF資料 |
PDF描述 |
|---|---|
| TISP61089BDR | TISP61089B High Voltage Ringing SLIC Protector |
| TISP61089BD-S | TISP61089B High Voltage Ringing SLIC Protector |
| TISP61089BDR-S | TISP61089B High Voltage Ringing SLIC Protector |
| TISP6L7591 | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP6L7591DR-S | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP61089BDR | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089BDR-S | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089BDR-T | 功能描述:SCR PROTECTOR - PROGRAMMABLE SLIC PROTECT RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089BDS | 制造商:Bourns Inc 功能描述: |
| TISP61089BD-S | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。