參數資料
型號： TEA1201TS
廠商： NXP SEMICONDUCTORS
元件分類： 穩壓器
英文描述： 0.95 V starting basic power unit
中文描述： 5 A SWITCHING REGULATOR, 720 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 4.40 MM, PLASTIC, MO-152, SOT-369-1, SSOP-16
文件頁數： 17/24頁
文件大?。?/td> 108K
代理商： TEA1201TS
2002 Jun 06
17
Philips Semiconductors
Product specification
0.95 V starting basic power unit
TEA1201TS
13.1
External component selection
13.1.1
I
NDUCTOR
L1
The performance of the TEA1201TS is not very sensitive
to inductance value. The best efficiency performance over
a wide load current range is achieved by using an
inductance of 6.8
μ
H for example TDK SLF7032 or
Coilcraft DO1608 range.
13.1.2
DC-
TO
-DC
CONVERTER INPUT CAPACITOR
C1
The value of C1 strongly depends on the type of input
source. In general, a 100
μ
F tantalum capacitor is
sufficient.
13.1.3
DC-
TO
-DC
CONVERTER OUTPUT CAPACITOR
C2
Thevalueand typeof C2 dependsonthemaximum output
current and the ripple voltage which is allowed in the
application. Low-ESR tantalum capacitors show good
results. The most important specification of C2 is its ESR,
which mainly determines output voltage ripple.
13.1.4
D
IODE
D1
The Schottky diode is only used for a short time during
takeover from N-type power MOSFET and P-type power
MOSFET and vice versa. Therefore, a medium-power
diode is sufficient in most applications, for example a
Philips PRLL5819.
13.1.5
F
EEDBACK RESISTORS
R1
AND
R2
The output voltage of the DC-to-DC converter is
determined by the resistors R1 and R2. The following
conditions apply:
Use SMD type resistors only with a tolerance of 1%.
If larger body resistors are used, the capacitance on
pin FB0 will be too large, causing inaccurate operation.
Resistors R1 and R2 should have a maximum value of
50 k
when connected in parallel. A higher value will
result in inaccurate operation.
Under these conditions, the output voltage can be
calculated by the formula:
13.1.6
C
URRENT LIMITING RESISTOR
R10
The maximum instantaneous current is set by the external
resistor R10. The preferred type is SMD with
1% tolerance.
The connection of resistor R10 differs for each mode:
At upconversion: resistor R10 must be connected
between pins ILIM and UPOUT/DNIN; the current
limiting level is defined by:
At downconversion: resistor R10 must be connected
between pins ILIM and GND0; the current limiting level
R10
is defined by:
The average inductor current during limited current
operation also depends on the inductance value, input
voltage, output voltage and resistive losses in all
components in the power path. Ensure that
I
lim
< I
sat
(saturation current) of the inductor.
13.1.7
R
EFERENCE VOLTAGE DECOUPLING CAPACITOR
C5
Optionally, a decoupling capacitor can be connected
between pin V
ref
and ground in order to achieve a lower
noise level of the output voltages of the LDO. The best
choice for C5 is a ceramic multilayer capacitor of
approximately 10 nF.
13.1.8
L
OW BATTERY DETECTOR COMPONENTS
R7, R8
AND
R9
Resistor R7 is connected between pin LBO and the input
or output pin and must be 330 k
or higher.
A 1-cell NiCd or NiMH battery can be connected directly to
pin LBI1.
A higher battery voltage can be detected by application of
a divider circuit with resistors R8 and R9. The low-battery
detection level for a higher battery voltage can be set by
using the formula:
Since current flows into the LBI1 pin, the parallel
impedance of R8 and R9 must be about 1 k
in order to
avoid inaccuracy due to the spread of the LBI1 current.
V
O
V
ref
1
R2
+
×
=
I
Iim
R10
=
I
Iim
300
=
V
LBI1(det)
V
det
R9
R8
×
=
相關PDF資料
PDF描述
TEA5768HL Low-power FM stereo radio for handheld applications
TEA5768 single-chip FM stereo radio
TEA6101 R-78xx-1.0 Series - Innoline Regulated DC-DC Converters; Output Voltage (Vdc): 3.3V; Output Current (A): 1.0A; Features: Efficiency up to 97%,Non isolated, no need for heatsinks; Pin-out compatible with LM78XX Linears; Low profile( L*W*H=11.5*8.5*17.5mm); Wide input range.(4.75V ~ 34V); Short circuit protection, Thermal shutdown; Non standard outputs available as specials between 1.5V ~15V; Low ripple and noise; ?L? version with 90?? pins
TEA6101T
TEA6310 Transient Voltage Suppressor Diodes
相關代理商/技術參數
參數描述
TEA1202 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Battery power unit
TEA1202TS 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Battery power unit
TEA1204 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:High efficiency DC/DC converter
TEA1204T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:High efficiency DC/DC converter
TEA1205 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:High efficiency DC/DC converter
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*