參數資料
型號: SI3050-E1-GM
廠商: Silicon Laboratories Inc
文件頁數: 77/128頁
文件大?。?/td> 0K
描述: IC VOICE DAA SYSTEM SIDE 24QFN
標準包裝: 75
系列: *
Si3050 + Si3011/18/19
52
Rev. 1.5
Figure 44. Monitor Handshake Timing
The Idle state is achieved by the MX and MR bits being held inactive (signal is high) for two or more frames. When
a transmission is initiated by a host device, an active state (signal is low) is present on the downstream MX bit. This
signals to the Si3050 that a transmission has begun on the Monitor channel and the Si3050 should begin accepting
data from host device. The Si3050, after reading the data on the Monitor channel, acknowledges the initial
transmission by placing the upstream MR bit in an active state. The data is received and the upstream MR
becomes active in the frame immediately following the downstream MX becoming active. The upstream MR then
remains active until either the next byte is received or an end of message is detected. The end of message is
signaled by the downstream MX being held inactive for two or more consecutive frames. Receipt of initial data is
signaled by the upstream MR bit’s transitioning from an inactive to an active state. Upon receiving
acknowledgement from the Si3050 that the initial data is received, the host device places the downstream MX bit in
the inactive state for one frame and then either transmit another byte by placing the downstream MX bit in an active
state again, or signal an end of message by leaving the downstream MX bit inactive for a second frame.
When the host is performing a write command, the host only manipulates the downstream MX bit, and the Si3050
only manipulates the upstream MR bit. If a read command is performed, the host initially manipulates the
downstream MX bit to communicate the command, but then manipulates the downstream MR bit in response to the
Si3050 responding with the requested data. Similarly, the Si3050 initially manipulates its upstream MR bit to
receive the read command, and then manipulates its upstream MX bit to respond with the requested data. If the
host is transmitting data, the Si3050 always transmits a $FF value on its Monitor data byte. While the Si3050 is
transmitting data, the host should always transmit a $FF value on its Monitor byte. If the Si3050 is transmitting data
and detects a value other than a $FF on the downstream Monitor byte, the Si3050 signals an Abort.
For read and write commands, an initial address must be specified. The Si3050 responds to a read or a write
command at this address, and then subsequently increment this address after every register access.
Transm itter
Receiver
1st Byte
2nd Byte
3rd Byte
MX
MR
ACK
1st Byte
ACK
2nd Byte
ACK
3rd Byte
125 s
MR
相關PDF資料
PDF描述
PIC16C56/JW IC MCU EPROM 1KX12 18CDIP
PIC16C55/JW IC MCU EPROM 512X12 28CDIP
SI3015-F-FS IC ISOMODEM LINE-SIDE DAA 16SOIC
SI3050-E1-FM IC VOICE DAA SYSTEM SIDE 24QFN
JBXEA2G07FSSDS CONN RCPT 7POS DOUBLE NUT SOLDER
相關代理商/技術參數
參數描述
SI3050-E1-GMR 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side
Si3050-E1-GT 功能描述:電信線路管理 IC System-side Voice DAA RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3050-E1-GTR 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side
Si3050-E-FM 功能描述:電信語音調制 IC Si3050 Voice DAA System-Side RoHS:否 制造商:Epson Electronics America 產品: 應用:Voice Guidance product 封裝 / 箱體:PQFP-52 電源電壓-最大:3.6 V, 5.5 V 最大工作溫度: 最小工作溫度: 封裝:
SI3050-E-FMR 功能描述:電信線路管理 IC Si3050 Voice DAA System-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray