參數資料
型號: SC16C550BIN40
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
中文描述: 1 CHANNEL(S), 3M bps, SERIAL COMM CONTROLLER, PDIP40
封裝: 0.600 INCH, PLASTIC, MO-015, SOT-129-1, DIP-40
文件頁數: 13/47頁
文件大?。?/td> 229K
代理商: SC16C550BIN40
Philips Semiconductors
SC16C550B
5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
Product data
Rev. 02 — 14 December 2004
13 of 47
9397 750 14446
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
6.4 Hardware/software and time-out interrupts
Following a reset, the transmitter interrupt is enabled, the SC16C550B will issue an
interrupt to indicate that the Transmit Holding Register is empty. This interrupt must
be serviced prior to continuing operations. The ISR register provides the current
singular highest priority interrupt only. Only after servicing the higher pending
interrupt will the lower priority be reflected in the status register. Servicing the
interrupt without investigating further interrupt conditions can result in data errors.
When two interrupt conditions have the same priority, it is important to service these
interrupts correctly. Receive Data Ready and Receive Time Out have the same
interrupt priority (when enabled by IER[0]). The receiver issues an interrupt after the
number of characters have reached the programmed trigger level. In this case, the
SC16C550B FIFO may hold more characters than the programmed trigger level.
Following the removal of a data byte, the user should re-check LSR[0] for additional
characters. A Receive Time Out will not occur if the receive FIFO is empty. The
time-out counter is reset at the center of each stop bit received or each time the
receive holding register (RHR) is read. The actual time-out value is 4 character time,
including data information length, start bit, parity bit, and the size of stop bit, i.e., 1
×
,
1.5
×
, or 2
×
bit times.
(1) RTS is de-asserted when the receiver receives the first data bit of the sixteenth byte. The receive FIFO is full after finishing
the sixteenth byte.
(2) RTS is asserted again when there is at least one byte of space available and no incoming byte is in processing, or there is
more than one byte of space available.
(3) When the receive FIFO is full, the first receive buffer register read re-asserts RTS.
Fig 8.
RTS functional timing waveforms, RCV FIFO trigger level = 14 bytes.
byte 14
byte 15
RX
RTS
IOR
(RD RBR)
Start
byte 18
Stop
Start
byte 16
Stop
002aaa051
RTS released after the
first data bit of byte 16
相關PDF資料
PDF描述
SC16C550IN40 Universal Asynchronous Receiver/Transmitter (UART) with 16-byte FIFO and infrared (IrDA) encoder/decoder
SC16C550 Universal Asynchronous Receiver/Transmitter (UART) with 16-byte FIFO and infrared (IrDA) encoder/decoder
SC16C550IA44 Universal Asynchronous Receiver/Transmitter (UART) with 16-byte FIFO and infrared (IrDA) encoder/decoder
SC16C550IB48 Universal Asynchronous Receiver/Transmitter (UART) with 16-byte FIFO and infrared (IrDA) encoder/decoder
SC16C554IB64 Quad UART with 16-byte FIFO and infrared (IrDA) encoder/decoder
相關代理商/技術參數
參數描述
SC16C550BIN40,112 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550IA44 制造商:NXP Semiconductors 功能描述:UART 16BYTE FIFO 16C550 PLCC44
SC16C550IA44,512 功能描述:UART 接口集成電路 16C 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550IA44,518 功能描述:UART 接口集成電路 16C 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550IA44,529 功能描述:UART 接口集成電路 16C 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel