- 您現在的位置：買賣IC網 > PDF目錄380638 > R2A20111SPW0 (Renesas Technology Corp.) Power Factor Correction Controller IC PDF資料下載
參數資料
| 型號： | R2A20111SPW0 |
| 廠商： | Renesas Technology Corp. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Power Factor Correction Controller IC |
| 中文描述： | 功率因數校正控制芯片 |
| 文件頁數： | 37/41頁 |
| 文件大小： | 310K |
| 代理商： | R2A20111SPW0 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁
R2A20111SP/DD
REJ03F0231-0100 Rev.1.00 Mar 28, 2007
Page 37 of 40
5. Precautions on Pins
5-1. OUT Pin
Undershoot may occur on the PWM pulse of the OUT pin because of a parasitic inductance of wiring, etc. This
undershoot (negative electric potential) may cause errors of the IC. In such a case, use a Schottky barrier diode, etc. to
suppress the undershoot.
5-2. DELAY Pin
When the voltage on the DELAY pin reaches 4 V or more, the shutdown function is operated and the IC enters the
shutdown state. Since the shutdown state is in latch mode, the IC is not resumed unless the voltage on the VCC pin is,
once, lowered to 4 V or below.
When the PFC hold function is not used, lower the DELAY pin capacitance as possible. However, connect a capacitor
with a few thousands pF or more capacitance to the DELAY pin so that the shutdown function will not be operated due
to noise, etc. and note wiring pattern not to catch the noise.
5-3. CAI Pin and CLIMIT Pin
These pins are connected to a current detection resistor via a resistor. Provide a rush-current protection circuit, not to
exceed the maximum rating because of the rush current at the startup of power supply.
5-4. VREF Pin
The voltage on the VREF pin is a reference voltage in the IC. For stabilizing the voltage on the VREF pin, be sure to
connect a capacitor between the VREF pin and GND. However, in capacitance of a capacitor to be connected,
overshoot may occur at the rising of the VREF pin (see figure 24). Pay special attention to this point when the voltage
on the VREF pin is used as the power supply for an external circuit and a reference voltage.
Furthermore, note that the source current of the VREF pin will not exceed the maximum rating.
Vref Overshoot
5
0.01
5.5
6
6.5
7
0.1
1
Cref (
μ
F)
V
Figure 24 Overshoot Amount on VREF Pin (Reference Data)
相關PDF資料 |
PDF描述 |
|---|---|
| R2J20601NP | Driver - MOS FET Integrated SiP (DrMOS) |
| R2J20701NP | N-channel TrenchMOS standard level FET, SOT78 (TO-220AB), Tube pack |
| R2KN | AVALANCHE DIODE |
| R2S15900SP | 2ch Electronic Volume with Surround |
| R2S15901SP | Digital Delay IC for Lip Sync |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R2A20112 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Renesas Low Noise & High Efficiency PFC Control IC |
| R2A20112ASP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Critical Conduction Mode Interleaved PFC Control IC |
| R2A20112ASP#W0 | 制造商:Renesas Electronics Corporation 功能描述:PFC IC - Tape and Reel 制造商:Renesas Electronics Corporation 功能描述:IC PFC CTRLR 24V 16SOP |
| R2A20112DD | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Critical Conduction Mode Interleaved PFC Control IC |
| R2A20112SP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Critical Conduction Mode Interleaved PFC Control IC |
發布緊急采購，3分鐘左右您將得到回復。