- 您現在的位置：買賣IC網 > PDF目錄361239 > Q67121C452 IC-SM-8-BIT CPU-12MHZ PDF資料下載
參數資料
| 型號： | Q67121C452 |
| 英文描述： | IC-SM-8-BIT CPU-12MHZ |
| 中文描述： | 集成電路釤8位CPU - 12MHz的 |
| 文件頁數： | 91/121頁 |
| 文件大?。?/td> | 1000K |
| 代理商： | Q67121C452 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁當前第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁
Power Saving Modes
C501
Semiconductor Group
8-2
8.2
Idle Mode
In the idle mode the oscillator of the C501 continues to run, but the CPU is gated off from the clock
signal. However, the interrupt system, the serial port, and all timers are further provided with the
clock. The CPU status is preserved in its entirety: the stack pointer, program counter, program
status word, accumulator, and all other registers maintain their data during idle mode.
The reduction of power consumption, which can be achieved by this feature depends on the number
of peripherals running. If all timers are stopped and the serial interfaces are not running, the
maximum power reduction can be achieved. This state is also the test condition for the idle mode
I
CC
.
So, the user has to take care which peripheral should continue to run and which has to be stopped
during idle mode. Also the state of all port pins – either the pins controlled by their latches or
controlled by their secondary functions – depends on the status of the controller when entering idle
mode.
Normally, the port pins hold the logical state they had at the time when the idle mode was activated.
If some pins are programmed to serve as alternate functions they still continue to output during idle
mode if the assigned function is on. This applies to the serial interface in case it cannot finish
reception or transmission during normal operation. The control signals ALE and PSEN are hold at
logic high levels.
As in normal operation mode, the ports can be used as inputs during idle mode. Thus a capture or
reload operation can be triggered, the timers can be used to count external events, and external
interrupts will be detected.
The idle mode is a useful feature which makes it possible to "freeze" the processor's status - either
for a predefined time, or until an external event reverts the controller to normal operation, as
discussed below. The watchdog timer is the only peripheral which is automatically stopped during
idle mode.
The idle mode is entered by setting the flag bit IDLE (PCON.0).
Note:
PCON is not a bit-addressable register, so the above mentioned sequence for entering the idle
mode is obtained by byte-handling instructions,
as shown in the following example:
ORL
PCON,#00000001B
;Set bit IDLE
The instruction that sets bit IDLE is the last instruction executed before going into idle mode.
There are two ways to terminate the idle mode:
– The idle mode can be terminated by activating any enabled interrupt. This interrupt will be
serviced and normally the instruction to be executed following the RETI instruction will be the
one following the instruction that sets the bit IDLE.
– The other way to terminate the idle mode, is a hardware reset. Since the oscillator is still
running, the hardware reset must be held active only for two machine cycles for a complete
reset.
相關PDF資料 |
PDF描述 |
|---|---|
| Q67126-C2088 | RF inductor, ceramic core, 2% tol, SMT, RoHS |
| Q67127-C2036SAB-C161R1-L16M | IC-SM-16 BIT CPU |
| Q67120-C2200 | 16-Bit Single-Chip Microcontroller Bare Die Delivery |
| Q67120-C1054 | High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125 |
| Q67120-C1056 | High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| Q67121-C848 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
| Q67121-C862 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:C16x-Family of High-Performance CMOS 16-Bit Microcontrollers |
| Q67121-C900 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
| Q67121-C923 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:C16x-Family of High-Performance CMOS 16-Bit Microcontrollers |
| Q67121-C942 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。